Merco BW-24 Installation Manual

INSTALLATION & OPERATING

INSTRUCTIONS

for

BUFFET WARMERS

MODEL SERIES BW & BWI

BWI MODELS HAVE SNEEZE GUARDS ON BOTH SIDES

Model BWI-24

ALL MODELS ARE AVAILABLE IN

120V, 120/208V AND 120/240V, SINGLE PHASE

TO BE SERVICED ONLY BY AUTHORIZED PERSONS

P/N: 001204 REV: 10/27/06

BEFORE INSTALLATION

NOTE: Upon receipt of this unit, immediately unpack and inspect for possible concealed shipping
damage. If unit is found to be damaged, save all packing materials and contact your delivery carrier
within 5 days. Refer to “Shipping Damage Instructions” enclosed for detailed instructions. Failure to
follow these instructions will negate Merco Savory’s or your ability to file claims and receive
compensation for shipping damage.

INSTALLATION

1. Check the specification data plate located on the control panel for the correct model number, voltage
and wattage.

2. Check to insure that the electric circuit being used to supply electricity to the unit has a sufficient
amperage rating.

3. Use the correct NEMA receptacle that corresponds to the plug provided with the unit.

4. Attach 4” (inch) Appliance Legs by threading the stud provided on the leg into the corner gussets on
the underside of the unit. Turn the adjustable feet on the appliance leg to level the unit. These legs
must be installed to allow heat to dissipate. Any warranty problems resulting from improper
installation will not be the responsibility of Merco Savory.

DIMENSIONS

(inches/cm)

OPERATION

#1 On/Off Switch controls lights for the upper and lower levels.

#2 Controls the tubular heating elements for the upper and lower levels.

#3 Illuminated Pilot Light indicates that tubular heaters are on.

#4 Controls black coated warming shelves for the upper and lower shelves.

#5 Illuminated Pilot Light indicates that the black coated warming shelves are on.