Merco 2TSW-2624 Installation Manual

operator manual

Single & Two-Tier Sandwich Warmers

This document includes:

• Mounting Type Information

• Installation Instructions

• Operating Instructions

• Cleaning Instructions

• Warranty Statement

P/N: 000354
Revision: C

SW & 2TSW Series

Shown without 4” legs (provided)

1111 North Hadley Road

Fort Wayne, Indiana 46804

United States of America

Technical Support Hotline: [phone]

Telephone: [phone]

www.mercosavory.com

Merco, LLC

BEFORE INSTALLATION

Upon receipt of this unit, immediately unpack and remove any protective packaging to inspect for possible concealed
shipping damage. If unit is found to be damaged, save all packing materials and contact your delivery carrier within fi ve
(5) days. If there is apparent damage:

In U.S.A. and Canada: Arrangements should be made to fi le a claim against the carrier as Interstate Commerce Regula-
tions require that the claim must be initiated by the consignee.

In Other Countries: Freight terms will be developed and extended on an individual basis.
Failure to follow these instructions will negate Merco’s or your ability to fi le claims and receive compensation for shipping

damage.

INSTALLATION

WARNING:

Check the specifi cation data plate for the correct model number, voltage and wattage.1.
Check to insure the electric circuit being used to supply electricity to the unit has a suffi cient amperage rating.2.
Use the correct NEMA receptacle that corresponds to the plug provided with the unit.3.

PERMANENTLY CONNECTED MODELS

1. For conduit connected units, some larger units may have double red and double black leads (208V and 240V) or
double white and double black leads (120V).

2. Double leads should be regarded as a single lead and connected to the corresponding wire from the power source
in accordance with the wiring diagrams provided.

CORD CONNECTED MODELS

1. For cordset equipped units, use the correct NEMA receptacle that corresponds to the plug provided with the unit.

FLUSH MOUNT MODELS

1. Attach the Flush Mount Brackets provided to the lower right and left end panels using screws provided. Holes in
Flush Mount Bracket will center to threaded holes in end panels.

2. Locate unit on counter or shelf, ensuring that the unit is not located closer than 3” (three inches) to a back wall.

3. Use holes provided in the foot of the Flush Mount Bracket to attach unit to the counter.

4. Using a silicone type sealer, apply a bead around the entire perimeter of the unit.

LEG ATT ACHMENT INSTRUCTIONS

1. Attach 4” (four inch) Appliance Legs by threading the stud provided on the leg into the corner gussets on the under­side of the unit. Turn the adjustable feet on the appliance leg to level unit. These legs must be installed to allow
heat to dissipate. Legs must be attached to meet NSF regulations. Any warranty problems resulting from improper

installation will not be the responsibility of Merco.

2. Locate unit on counter shelf, ensuring that the unit is not located closer than 3” (three inches) to a back wall.

Check to insure that a minimum clearance of 3” (three inches) is maintained from back wall.

DIMENSIONS

(inches / cm)

Model SW-3824 Shown

Model 2TSW-3824 Shown

24 / 61

20.9 / 53.1

LENGTH

24 / 61

33.1 / 84.2

LENGTH

SPECIFICATIONS

(Standard Models)

MODEL

SW-2624 7.7 N/A N/A 920 26/66.0 70/31.8 10/45.4 9.5/0.27
SW-3824 11.8 7.7 6.9 1420 38/96.5 110/49.9 150/68.1 13.5/0.38
SW-5024 15.0 9.7 8.8 1800 50/127.0 150/68.1 190/86.3 17.4/0.49
SW-6224 18.8 12.1 10.9 2260 62/157.5 200/90.8 250/113.5 21.3/0.60
2TSW-2624 15.3 8.0 N/A 1840 26/66.0 100/45.4 130/59.0 15.0/0.42
2TSW-3824 23.7 15.4 13.8 2840 38/96.5 150/68.1 190/86.3 21.1/0.60
2TSW-5024 N/A 19.4 17.5 3600 50/127.0 200/90.8 250/113.5 27.3/0.77
2TSW-6224 N/A 24.3 21.8 4520 62/157.5 250/113.5 320/145.3 33.5/0.95
2TSW-3224 18.8 12.1 11.0 2620 32/81.3 140/63.5 180/81.6 13.2/0.37
2TSW-4424 N/A 17.0 15.3 3180 44/111.8 170/77.1 220/99.8 18.2/0.52
2TSW-7424 N/A 28.2 25.2 5340 74/188.0 240/108.9 320/145.0 30.6/0.87
2TSW-8024 N/A 32.0 28.7 6040 80/203.2 270/122.5 360/163.3 33.1/0.94

* Measurements are approximate.
NOTE: Not all units are available in all voltages.

VOLTAGE / AMPS

120V 120/208V 120/240V

WATTS

LENGTH

INCHES / CM

NET WT**

LBS/KG

SHIP WT**

LBS/KG

CU FT / CU M

SHIP VOL**