Merax WF186995JAA User Manual

R

Barber Chair

Model# WF186995JAA

OWNER’S MANUAL

E-mail: [e-mail]

Tel: [phone] Ext. 100

CAUTION! Do not use this product

!

before reading the instructions.

Table of Contents

Parts --------------------------------------------------------------------------------------------------

Assembly -------------------------------------------------------------------------------------------

Instructions for

Use ------------------------------------------------------------------------------

03

04

05

2
3

P

ARTS

1. Backrest x 1

3. Armrest x 2

5. Hex Screw M8*35 x 2

7. Oil Pump Shell x 1

9.

Lock Nut M8*10 x 2

11. Oil Pump x 1

13. Base x 1

15. Open-ended Wrench 14mm x 1

17. Allen Key 5mm

19. Decorative Block

Note: All screws are preinstalled in the appropriate position.

2. Seat x 1

4. Socket Hex Screw M8*60 x 4

6. Screw M5*12 x 1

8. Hex Screw M8*30 x 2

10. Footrest x 1

12. Foot Pump Pedal x 1

14. Socket Hex Screw M6*12 x 6

16. Allen Key 6mm x 1

18. Allen Key 4mm x 1

FIRST TIME USE

STEP ONE: Base Installation

Attach the oil pump (11) to the base (13) of the
chair with socket hex screws (14) and tighten
the screws with Allen key (17).

Insert oil pump shell (7), line up the holes both
on the shell and the oil pump (11) , attach them
with screws(6) by Allen key (17).

Attach the foot pump pedal (12) to pump(11) and
tighten them with screws(9) on each side with
Allen key (18).

*Make sure foot pump is installed correctly as shown in
image. Incorrectly installed foot pump will cause severe
damage to chair. *

Note: !!!!!!Foot pump and pump cover are on the opposite side!!!!!!!!

STEP TWO: Seat Installation

Align the two holes on backrest (1) and seat (2),
and tighten the hex screw (5) with wrench (15).

Line up the two holes on the armrest (3) respectively
with those on backrest(1) and seat (2), fix with screw
(4). Make sure you adjust all parts properly with correct
tool. Then plug the decorative block (19).

4

STEP THREE: Footrest Installation

The foot screws are preloaded at the bottom of the seat
cushion. Remove the screws(8) first before aligning the

holes on foot rest(10) and those under the seat, put back
the screws and tighten with wrench(15).

STEP FOUR: Combine the Seat:

Attach the assembled seat to the pump, sit on it, and there
you go.

Note: No screws are needed to connect the seat and the base.

The longer you seat, the tighter it gets.

How to lift and lower the chair:

Step on the foot lever and PEDAL to lift the chair.

Floor the lever to lower the chair.

5