Meopta FLEXARET AUTOMAT VI User Manual

FLEXARET AUTOMAT VI

The Flexaret twin lens reflex cameras are a product of the Czechoslovakian company
Meopta (manufacturers of enlarging equipment). The Flexaret Automat VI was in
production from 1961-1967. This camera is a multiformat camera, 6x6 and 35 mm.

The picture shows the 35 mm insert,
35mm film cartridge adapters and
take up spool required to
accommodate 35mm film. The
insert goes into the film chamber.

The 35mm film goes under the shiny
small rollers and over the small
brown rollers on the frame spacing
control roller. This is how the
camera knows that the spacing needs
to be for 35mm film vs. 120 film. If
the camera shutter is cocked without film in the camera, the film counter reset lever needs
to be held down while rotating the frame spacing control roller until a number 1 – 12
shows in the frame counter window, then the shutter button can be pressed. When the
end of the 35mm cartridge is reached, the center button of the film wind knob is
depressed (and held) while the film spool knob on the lower left of the camera is turned
clockwise to rewind the film back into the 35mm cartridge.

When the 35mm film insert is installed, the number 35 shows in a window at the back of
the camera to indicate 35mm film is installed. The number 60 shows when 120 film is
used.

When the camera is loaded with 35mm film,
you need to rotate the frame counter reset knob
behind the frame counter ¼ turn after every
10th picture. Rotating the reset knob causes the
frame counter to return to 1. Otherwise, the
counter will go to frame 11, 12 and then red
dots with no frame spacing control. In other
words, you will not get all of the pictures on
your roll of 35mm film, the film will wind all

of the way to the end without stopping. The
reset knob has an indexing window with the numbers 0, 1, 2 and 3. This allows you to
keep track of the number of pictures that you have taken. For example, on a 36 exposure
roll of 35mm film, if you remember to turn the index lever to the next number after every
10th exposure, you would have a 3 index and a 6 film counter number for the 36th
exposure.

The button above the shutter release is a shutter release-locking switch,
red indicates the shutter is not locked.

On the upper left side of the camera is the camera back release button.
The button unscrews several turns and then pushes in to release the
camera back. To prevent accidental door opening, it is recommended
that the button be turned all of the way in.