Mennekes Electrical Products SPEC Grade Series brochure

SPEC Grade Series

Motor Disconnects

and Switched Receptacles

www.MENNEKES.com

A New Angle on Clean...

SPEC Grade

®

by MENNEKES

Motor Lockout/Tagout

requirements exist in all plant

environments BUT finding

a compact solution in

critical wash down and

clean room areas

remains a challenge.

MENNEKES is proud

to offer SPEC Grade

Motor Disconnects

and Interlocked

Receptacles, both in

sloped-top enclosures

for the ultimate

clean installation.

The SPEC Grade Motor

Disconnect Switches

are offered in 3 sizes

of NEMA 4X enclosures

to provide for flexibility

in design and budgets.

All models have

padlockable handles

to comply with OSHA

LO/TO regulations.

Innovative Series of Sloped-Top Disconnects

Sealed NEMA 4X; 12 Enclosure

• 304 Stainless with low RA value finish

• Broad switch selection, rated 25A-100A
from 5HP to 50HP

• Early break auxiliary contacts for VFD
and starter interface

• Generous wiring space
facilitates installation

• Sealed fixing holes
for flush rear-wall
mounting

• Ground stud provided

• Removable cover with
captive hardware

Small Footprint

One-piece punched gasket
for watertight seal

Option

• Compact size

• Value priced

• Same great
features

Switched Receptacle Version

• Interlocked for safety

• Complies to Lockout/Tagout

• Available 20A & 30A Pin and Sleeve styles

Superior Enclosure Design

• 15° Sloped roofs to facilitate run-off of liquids

• “Clean” high visibility RED/YELLOW operator handle

• Generous drainage channel to impede harborage
of contaminants

• Shrouded handle to minimize damage

Switches meet code

requirements for

“suitable as a motor

disconnect”. Housed
in 304 Stainless Steel

enclosures, units are
designed for the
harshest of operating
conditions. This range
of switches satisfies

most line motor

disconnect needs.

SPEC Grade Switched

and Interlocked

Receptacles are an

INDUSTRY FIRST.

Housed in a NEMA 4X

stainless steel sloped-

top enclosure, units

are available in 20A and

30A IEC 60309 Receptacle

Configurations for

compatibility with like rated

competitors. Receptacle

and switch are factory wired;

patented interlock mechanism

assures “NO LOAD” make

and break of plug connected

equipment for operator safety.