Mennekes Electrical Products HDI DISCONNECT SWITCHES Wiring Instructions

MENNEKES
Mounting Instructions
Direct Mount Using Mounting Tubes
OR
1. Position Box Upright using Top Label as Indicator.
2. Drop #10 Screw into each Mounting Tube. See Fig. 1a Below.
3. Mount Unit on Secure Flat Vertical Surface.
4. Reinstall Hinged Cover. See Below.
Fig. 1a
Fig. 1aFig. 1aFig. 1a
TOP
Mounting Tubes
Use #10 Screw
Mount with External Mounting Feet
(Kit Provided)
1. Turn Bottom Box Over to Expose Threaded Rivets.
2. Screw Mounting Feet into Corner Rivets, Position Mounting Feet as Required. See Fig. 2a Below.
3. Position Box Upright Using Top Label as Indicator.
4. Mount Unit to Flat Vertical Surface. (hardware not provided)
5. Reinstall Hinged Cover. See Below.
Fig. 2a
TOP
8.86”
DO NOT MOUNT
THROUGH REAR WALL
OF BOX
6”
11.654”
DO NOT MOUNT
THROUGH REAR WALL
OF BOX
4.815”
Hinged Cover Installation
1. Position Cover so “ON” is in Top Position.
2. Align Radius (Curved) Side of Both White Extension Pieces to Radius (Curved) side of Mounting Tubes.
3. Push Extension Pieces into Tube, Approx. 1”. Extensions will Snap into Place
4. Handle Must be in “OFF” Position and Aligned to Switch. Tighten Cover Screws 25 lb.-in.
10.736”
Loading...