Mencom MCV Series, MCVH Series, MCX Series, MCL Series Accessories Catalog

MCV, MCVH, MCX & MCL Series Accessories

MCV, MCVH, MCX & MCL Series Tools

Crimping Tool | Gage | Locators | Assembly Tool

Crimping Tool

Body Style Part Number Description

The CCPZ-MIL crimping tool conforms to the international standard
MIL-C-22520/1. The crimping is performed with 8 pressure points. The tool

CCPZ-MIL

is equipped with a ratcheting mechanism to insure a complete crimping
cycle is performed every time. This tool must be equipped with one of the
interchangeable locators according to the series of contacts that are to be
crimped. The selector dial on the side of the tool to adjust the crimp depth
according to the contact and wire size being crimped.

CCPNP

MCV-001

Go - No Go Gauge

The indenting “teeth” on the crimp tool are subject to wear, so it is important to
check the calibration of the tool at regular intervals. The CCPNP gauge is a Go ­No Go Gauge that is used to make sure the tool is crimping properly.

1. To use the CCPNP, put the CCPZ-MIL selector dial to position 4.

2. Put the crimping tool in a completely closed position.

3. “GO” -- Insert the “GO” (green) end of the CCPNP into the crimp area. The
gauge must pass freely between the indenter “teeth”.

4. “NO-GO” --Insert the “NO-GO” (red) end of the CCPNP into the crimp area.
The gauge must not pass between the indenter “teeth”.

5. If the NO-GO end of the gauge passes through the indenter “teeth”, the
indenters are worn and need to be replaced.

Please consult the factory to get the tool repaired.

Assembly Tool

MCV-001 is an assembly tool to aid in the assembly of the MCV eld wireable

connectors that have female couplings. The MCV-001 will hold the connector
and prevent it from rotating while the connector backshell is threaded onto the
back of the connector.

E

M16, M23 & M27 Series

Locators

Body Style # of Poles Part Number Description

6 & 7 MCTP-V6

MCV

MCVH 6 & 8 MCTP-VH6-8

Mencom understand that many customers have a one-time requirement of the MC Series of product and prefer not to purchase tooling to perform the
crimping. To help these customers, Mencom has a month to month tool lease program. Please consul the factory for information about this program.

12 MCTP-V12

19 MCTP-V19

The locator is designed to be used with several different
contacts within a contact series. The label on the side of
the locator will indicate the proper setting for the locator
and the crimp tool relative to the contact being crimped.

E-27