Memorex Mi1006 User Manual
Mi1006
User’s Guide
iListen with AM/FM Radio
Before operating this product,
please read these instructions completely.
SAFETY PRECAUTIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
DANGEROUS VOLTAGE:
The lightning flash with arrowhead symbol within an
equilateral triangle is intended to alert the user to the
presence of uninsulated dangerous voltage within the
product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
ATTENTION:
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The
user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
ATTENTION:
POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA
PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE
LA PRISES ET POUSSER JUSQU’AU FOND.
1
SAFETY PRECAUTIONS
INFORMATION:
This equipment complies with Class B digital device regulations.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN
OR MOISTURE.
SURGE PROTECTORS:
It is recommended to use a surge protector for AC connection.
Lightning and power surges ARE NOT covered under warranty
for this product.
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
2
17
18
MAIN UNIT
LOCATION OF CONTROLS
1. Left Speaker
2. Headphones Jack
(Side of Unit)
3. LINE IN Jack
(Side of Unit)
4. iPod®Dock with
Connector &
Interchangeable Holders
5. MODE Button
6. VOLUME Up/Down
Buttons
7. Power Button
8. S-Video Jack
(Rear of Unit)
9. AM Loop Antenna Jack
(Rear of Unit)
10.Display
11.Right Speaker
12.PRESET Button
13.TUNE Up/Down/Skip n
/ o Buttons
14.SET Button
15.POWER IN Jack
(Rear of Unit)
16.FM Wire Antenna
(Rear of Unit)
17.Remote Sensor
18.Stand (Removable)
3
LOCATION OF CONTROLS (CONTINUED)
REMOTE
1. Battery Compartment
(Side of Unit)
2. TUNE Down/Skip o
Button
3. VOLUME Down Button
6. PRESET Button
7. Power/PLAY/PAUSE
(®p) Button
8. TUNE Up/Skip n Button
9. Belt Clip
4. MODE Button
5. VOLUME Up Button
NOTES:
• The remote buttons function in the same way as the buttons on
the main unit.
• For the Belt Clip, simply clip it to to a non-slip location such as
your belt, purse or backpack.
• To turn on the unit, press the Power/PLAY/PAUSE (®p) button.
To turn the unit off, press and hold the Power/PLAY/PAUSE
(
®p) button until the display turns off, then release the button.
4
POWER SOURCE
AC Plug
AC Outlet
AC CONNECTION
Insert the small end of the AC adapter into the POWER IN jack (located on the rear of
the unit). Connect the AC cord to the adapter and connect the other end to a wall outlet
having 120V AC, 60 Hz. AC Adapter, DC 20V
NOTES:
• The AC adapter supplied with the unit is polarized to help minimize the possibility
of electric shock. If the AC plug does not fit into a nonpolarized AC outlet, do not
file or cut the wide blade. It is the user’s responsibility to have an electrician replace
the obsolete outlet.
• Remove both the DC plug and the AC-IN plug to disconnect the AC adapter when
not in use.
• Only use the supplied AC Adapter which has the following specs: DC 20V
REMOTE BATTERY INSTALLATION
1.
2. Install a CR2025 battery, paying attention
3. Replace the Battery Compartment.
Z
Z
Remove the Battery Compartment by
pressing in on the tab and then sliding the
compartment out.
to the polarity diagram in the Battery
Compartment (positive side up).
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as
indicated in the Battery Compartment. A reversed battery may cause
damage to the device.
3. If the device is not to be used for a long period of time, remove the
battery to prevent damage or injury from possible battery leakage.
4. Do not try to recharge a battery not intended to be recharged; it can
overheat and rupture. (Follow battery manufacturer’s directions.)
BATTERY PRECAUTIONS
5
Loading...