Memorex MB211 User Manual

Before operating this product,
please read these instructions completely.
User’s Guide
Armband AM/FM Radio
with Alarm Clock
MB211
MB211.O/M.QXD 7/22/03 1:49 PM Page 10
BATTERY INSTALLATION
BATTERY INSTALLATION: Open the battery compartment by sliding it downward and lifting it up. To prevent the possibility of losing the cover, it cannot be removed.
Insert two (2) "AAA" size batteries (not included) following the polarity diagram. Slide the battery compartment back in place.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specied.
2. Be sure to follow the correct polarity when installing the batteries, as indicated on the battery compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline, Carbon-zinc and Rechargeable) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)
Thank you for purchasing this Memorex audio system.
The serial number of your unit can be found on a label on the rear of the cabinet. We suggest that you record the serial number in the space provided below in case this information is ever needed at a future date.
PLEASE KEEP ALL PACKAGING MATERIAL FOR AT LEAST 90 DAYS IN CASE YOU NEED TO RETURN THIS PRODUCT TO YOUR PLACE OF PURCHASE OR TO MEMOREX.
Model Number: MB211
Serial Number: _______________________________________
IMPORTANT NOTE WHEN CHANGING BATTERIES:
Make sure to change the batteries within 30 seconds, otherwise the time and memory may be lost.
MB211.O/M.QXD 7/22/03 1:49 PM Page 1
+
+
LOCATION OF CONTROLS
1. Battery Compartment (Rear of
Unit)
2. Armband Strap Holder (Rear
of Unit)
3. Earbud Jack
4. AM/FM Dial Scale and Pointer
5. Function (OFF/FM/AM) Switch
6. VOLUME Control
7. Time Display
8. Armband Release Button
(Rear of Unit)
9. SET Button
10. MODE Button
11. TUNING Control
12. BASS (ON/OFF) Switch
MB211.O/M.QXD 7/22/03 1:49 PM Page 2
3
107 98 12
11
61 2 54
INSTALLATION
Insert the belt strap into the belt clip, then fold the belt strap and fasten the velcro.
1
Insert the belt clip into the main unit, then push the belt clip until it locks in place at the end of the belt clip holder.
2
Straighten the other side of the belt, then put the belt around your arm (it will rope your arm itself). Fasten the velcro so the unit is secure.
3
TO REMOVE THE BELT CLIP:
Press and hold the Belt Clip release button, then push the belt clip out to remove it from the unit.
4
TO USE THE ARM STRAP
EARBUDS:
Included with this unit are earbuds. Make sure the VOLUME control is at minimum and insert the earbud plug into the earbud jack on the top of the unit. Place the earbuds into your left and right ears, corresponding to the “L” and “R” mark on each earbud. NOTE: You must have the earbuds plugged in to hear the alarm sound.
MB211.O/M.QXD 7/22/03 1:49 PM Page 3
OPERATION
Insert the earbuds into the Earbud jack and slide the Function switch to select AM or FM.
1
Rotate the TUNING control to tune a station.
2
Adjust the VOLUME control and BASS switch as desired.
3
When done listening, slide the Function switch to the OFF position.
4
TO LISTEN TO THE RADIO
Antennas
FM: Extend the earbud wire for best reception.
AM: Turn the unit for better AM reception.
To emphasize the bass, slide the BASS switch to the ON position. Slide to the OFF position to turn the bass feature off.
1
BASS BOOST
MB211.O/M.QXD 7/22/03 1:49 PM Page 4
1
2
1
2
OPERATION (CONTINUED)
Press the SET button again; the hours will appear. Repeatedly press the MODE button until the desired hour appears. Make sure to set the correct AM/PM or 24 hour time setting.
3
Press the SET button again; the minutes will appear. Repeatedly press the MODE button until the desired minute appears. Press the SET button then the MODE button and the time will be set.
4
TO SET OR RESET THE ACTUAL TIME AND DATE
Press the SET button four times; the month will appear. Repeatedly press the MODE button until the desired month appears.
1
Press the SET button again; the day will appear. Repeatedly press the MODE button until the desired day appears.
2
MB211.O/M.QXD 7/22/03 1:49 PM Page 5
1
1
2
2
1
1
2
2
OPERATION (CONTINUED)
Press the SET button twice; the alarm hour will blink. Repeatedly press the MODE button until the desired alarm hour appears. Make sure to set the correct AM/PM or 24 hour time setting.
1
Press the SET button again; the alarm minutes will blink. Repeatedly press the MODE button until the desired alarm minute appears. Press the SET button again and the alarm time will be set.
2
TO SET OR RESET THE ALARM TIME
Set the alarm time as previously instructed. Press the SET button once; the alarm time will blink. Press the MODE button
once to activate the alarm; the
alarm indicator (“ ”) will appear. Press the MODE button
a second time to
activate the alarm and the Hourly Beep feature (explained on next page); the Alarm indicator (“ ”) and Beep indicator (“ ”) will appear. Press the SET button
three times to return to the Time display. When the actual time matches
the selected preset alarm time, the alarm (beep sound) automatically turns on. To shut off the alarm, see TO SHUT THE ALARM OFF section on the next page.
)
)
)
1
TO TURN THE ALARM ON
NOTES:
• You must have the earbuds plugged in and be listening to the radio to hear the alarm sound.
• The alarm will be a beeping sound; you cannot set the unit to wake to the radio sound.
• The alarm will sound for 30 seconds when it reaches the alarm time.
MB211.O/M.QXD 7/22/03 1:49 PM Page 6
1
)))
)))
2
1
2
1
)
)
2
OPERATION (CONTINUED)
To shut the alarm off, when the alarm is sounding, press the SET button once and the alarm time will be reset for the next day. To turn off the alarm and not set it for the next day, press the SET button again, then press the MODE button until the Alarm indicator (“ ”)
disappears to deactivate the alarm. Press the SET button until the current time appears in the display.
)
1
TO SHUT THE ALARM OFF
The alarm can be temporarily turned off manually by pressing the MODE button when the alarm is sounding; the Alarm indicator
(“ ”) will blink in
the display. The alarm will turn back on automatically five minutes later.
)
1
SNOOZE
When this feature is activated, a beep will be heard every hour, when listening to the radio. Press the SET button once; the alarm time will blink. Press the MODE button
twice to activate the alarm and the Hourly Beep feature; the
Alarm indicator (“ ”) and Beep indicator (“ ”) will appear. Press the MODE button
a third time to activate the Hourly Beep feature only; the Beep indicator
(“ ”) will appear. Press the SET button
three times to return to the Time
display.
)
)
)
1
TO SET THE HOURLY BEEP
NOTE: You must have the earbuds plugged in and be listening to the radio to hear the alarm sound.
MB211.O/M.QXD 7/22/03 1:49 PM Page 7
1
)
)
2
1
)))
2
)))
)))
)
)
TROUBLESHOOTING GUIDE
If you experience a problem with this unit, check the chart below before calling for service.
SYMPTOM
POSSIBLE POSSIBLE CAUSE SOLUTION
RADIO
No sound. The earbuds are not Plug in the earbuds.
connected.
VOLUME control at min- Increase the VOLUME
imum position. control.
Noise or sound AM: Interference from Turn the radio for
distorted on AM traffic. better AM reception.
or FM. FM: Earbud wire is Extend Earbud wire.
not extended.
CLOCK
Time is not set. Battery connected Check the battery and/
improperly, not con- or replace battery.
nected or dead.
Clock is not set. Set the clock.
Alarm does not Clock is not set. Set the clock.
sound. Alarm time is not set. Set alarm time.
FOR ADDITIONAL SET-UP OR OPERATING ASSISTANCE, PLEASE VISIT
OUR WEBSITE AT:
WWW.MEMOREXELECTRONICS.COM
OR CONTACT CUSTOMER SERVICE AT 1-800-919-3647.
PLEASE KEEP ALL PACKAGING MATERIAL FOR AT LEAST 90 DAYS IN CASE YOU NEED TO RETURN THIS PRODUCT TO YOUR PLACE OF PURCHASE OR TO MEMOREX.
FOR PARTS AND ACCESSORIES, CONTACT FOX INTERNATIONAL AT 1-800-321-6993.
MB211.O/M.QXD 7/22/03 1:49 PM Page 8
Memcorp, Inc.
Weston, FL
Printed in Hong Kong
Visit our website at www.memorexelectronics.com
MB211.O/M.QXD 7/22/03 1:49 PM Page 9
Loading...