Waterbath
WNB 7 - 45
OPERATING INSTRUCTIONS
Always use gloves!
Ambient conditions
Ambient temperature 5ºC - 40°C
A material-compatibility table covering all these materials can be requested from MEMMERT.
regulations which apply (e.g. in Germany DIN VDE 0100 with FI protection circuit)
at the transfer
Any work which involves opening up the bath must only be
Any work which involves opening up the bath must only be
which cannot tilt.
remain unobstructed. Minimum wall spacing on all
7 5. 0
A parameter can be selected by rotating the push/turn control; all other parameters are then dimmed.
After the SET key has been released the newly set value is stored.
Adjustment range:
Adjustment range:
°C
symbol fl ashes.
symbol fl ashes in proportion to the actual heater power.
Activating the
°C
°C
Adjustment range:
Adjustment range:
hrs
min
(delay) and the
symbol fl ashes.
ϑ
t
90°C
ϑ
t
delay 12h
90°C
Adjustment range:
Adjustment range:
hrs
min
(hold) and the
symbol fl ashes.
°C
symbol fl ashes. With the SET key
°C
(delay) and the
symbol fl ashes.
hours.
(hold) and the
symbol fl ashes. With
ϑ
t
90°C
hold 6h
symbol
°C
After the end of the delayed switch-on the
symbol.
°C
symbol fl ashes
°C
After the hold time has elapsed the
symbol
°C
ϑ
t
90°C
hold 4h
delay 6h
ϑ
t
90°C
delay 6h
hold 4h
ϑ
t
90°C
hold 4h
delay 6h
ϑ
t
90°C
delay 6h
hold 4h
All waterbaths are fi tted with a mechanical temperature limiter (TB)
symbol
continuously as warning.
symbol
continuously.
customer service
as warning.
After cleaning and after draining the water the
After cleaning and after draining the water the
After a failure of the supply, operation continues with the previously set parameters.
symbol not alight
Ambient temperature too high
symbol alight
symbol fl ashes
EC Declaration of Conformity
Manufacturer´s name and address: MEMMERT GmbH + Co. KG
Äußere Rittersbacher Straße 38
D-91126 Schwabach
Product: Waterbath
Type: WNB...
Sizes: 7 / 10 / 14 / 22 / 29 / 45
Nominal voltage: AC 230 V 50/60 Hz
alternative AC 115 V 50/60 Hz
The designated product is in conformity with the European EMC-Directive
2004/108/EEC
including amendments
Council Directive of 03 May 1989 on the approximation of the laws of the Member States relating to
electromagnetic compatibility.
Full compliance with the standards listed below proves the conformity of the designated product with the essential
protection requirements of the above-mentioned EC Directive:
DIN EN 61326:2004-05 EN 61326:1997
EN 61326/A1:1998
EN 61326/A2:2001
EN 61326/A2:2003
The designated product is in conformity with the European Low Voltage Directive
2006/95/EEC
including amendments
Council Directive on the approximation of the laws of the Member States relating to Electrical
equipment for use within certain voltage limits.
Full compliance with the standards listed below proves the conformity of the designated product with the essential
protection requirements of the above-mentioned EC Directive:
DIN EN 61 010-1 (VDE 0411 part 1):2002-08 EN 61 010-1:2001
DIN EN 61 010-2-010 (VDE 0411 part 2-010):2004-06 EN 61 010-2-010:2003
Schwabach, 03.07.08
______________________________
(Legally binding signature of the issuer)
This declaration certifies compliance with the above mentioned directives but does not include a property assurance. The
safety note given in the product documentation which are part of the supply, must be observed.
Address and
© by MEMMERT GmbH+Co.KG
Memmert GmbH + Co. KG | Postfach 1720 | D-91107 Schwabach | Tel. +49 (0) 9122 / 925 - 0 | Fax +49 (0) 9122 / 145 85 | E-Mail: sales@memmert.com | www.memmert.com
15.06.2018
Waterbath BASIC englisch
D10329
Loading...