Memmert Water Bath WB-OB 7-45 Service manual

SERVICE-MANUAL

WB/OB 7- 45

7 / 98

1

WB/OB 7- 45

WB/OB 7- 45

2

TABLE OF CONTENTS

1 Removing the side panel.............................................................................................4

2 Changing the main switch module.............................................................................5

3 Changing the controller module.................................................................................5

4 Changing the temperature sensor..............................................................................6

5 Changing the temperature limiter...............................................................................7

6 Changing the interference filter..................................................................................7

7 Changing the fuse for unit protection........................................................................7

8 Changing the teflon sealing ........................................................................................8

9 Our address..................................................................................................................8

10 Wiring diagram WB7, 10, 14 tb ...................................................................................9

11 Wiring diagram WB 22, 29, 45 tb ................................................................................10

3

WB/OB 7- 45

Instructions for repair

This Service – Manual contains instructions for the repair of MEMMERT baths.
For maintenance works please see the Operation Instructions added to each
unit.
We point out that actions which require disassembly (even in part) of the unit
have to be carried out by experts only.

The dismantling and dismounting of parts is described in this document down
to the module level, because spare parts usually are replaced as complete
modules only.

Please note the safety instructions and general directions of the

Operating Instructions added to the unit.

ATTENTION!

Before removing the side panel – pull out the plug

and remove the liquid of the bath !!

Separating the unit sets free raw metal edges – therefore

always use gloves!

This Service – Manual describes the steps for the dismounting of the unit.
Reassembly is done in reverse order, if not stated differently.

1 Removing the side panel

¦

Pull out the plug.

¦ Place the bath on a table so that the

feet of the unit fits with the edge of
table.

¦ Put out the screws at the bottom of

the side panel.

¦ Remove the side panel downwards.

WB/OB 7- 45

4