Mellerware EVE STEAM IRON 23009, 23009 Instructions Manual
2 y e a r g u a r a n t e e
C O N T E M P O R A R Y
E v e S t e a m I r o n
Model:
2 3 0 0 9
120 0 W
PLEASE READ ALL INSTRUCTIONS BEFORE USE
SABS
IEC60355
IMPORTANT SAFEGUARDS
1. Please read all instructions carefully before using the
appliance for the first time.
2. Before connecting the appliance, check if the voltage
indicated on the rating label corresponds with the
mains voltage in your home.
3. Do not use appliance for anything other than its
intended use.
4. The iron should always be switched off before
connecting or disconnecting from the power supply.
Do not pull on the cord to disconnect the plug from the
wall socket.
5. Do not use the iron when it is damaged in any way.
Do not operate the iron with a damaged cord or plug.
Do not replace the power cord or any other parts
by yourself. Bring the iron to the nearest authorized
service facility or to the shop where you bought it, as
special tools are required for repair.
6. When you have finished ironing or when you only
leave it for a short while, stand the iron upright and
then disconnect the iron from the wall outlet.
7. Do not allow children to touch the iron or the power
cord when ironing.
8. Do not immerse the iron or the cord into water or any
other liquid.
9. Do not touch hot metal parts, hot water or steam.
These parts become hot and may cause burns.
10. The plug and cord should not be allowed to touch the
hot soleplate. Let the iron cool down completely before
taking it away.
11. Disconnect the iron from the wall outlet for pouring in
water or when you remove the water after use.
12. To avoid an overloaded circuit, do not operate another
high voltage appliance in the same electric circuit.
13. Never use an extension power cord set that is not
approved by a competent authority. The cord should
be arranged in a way that it cannot be pulled or tripped
over.
14. The iron is for household use only.
SAVE THE INSTRUCTION MANUAL FOR
FUTURE REFERENCE
• Some parts of the iron have been slightly greased and
as result the iron may smoke slightly when switched
on for the first time. It will not happen again after a few
uses.
• Before using for the first time, remove any protective
films or stickers from the soleplate and the cabinet.
• Then clean the soleplate with the soft cloth. When
using the iron for first time, test it on an old piece of
fabric to ensure that the soleplate and water tank are
completely clean.
KEY and CHARACTERISTICS
X
KIND OF TEXTILE
Synthetic
Synthetic
Wool
FIBRE MATERIAL
Acrylic
Modacryl
Polypropylene
Polyurethane
Acetate
Triacetate
Synthetic
Silk
Metallized
Cupro
Polyamide (Nylon)
Polyester
Modal
Viscose (Rayon)
Silk
Wool
Cotton
Linen
Cotton
Linen
LABEL
NOTE:
On label means: THIS ARTICLE
CANNOT BE IRONED!
(eg: Chlorofibre, Elastodiene)
Description
1. Soleplate
2. Heat-insulated plate
3. Spray nozzle
4. Water tank
5. Spray button
6. Steam button
7. Pilot light
8. Temperature control knob
9. Handle
10. Front cover
11. Back cover
12. Power supply cord
Loading...