Meliconi Control 2 digital CME User Manual

Keep this booklet for future reference.

IMPORTANT: The remote control must not be exposed to excessive heat sources.

EN

I

Digital

Thank you for choosing a CME remote control.

The Control 2 Digital remote control is ideal for replacing up to 2 remote controls for TV - STB (satellite decoder or
Digital Terrestrial decoder). The remote control has a permanent memory, so it does not lose its settings even if there are
no batteries in it.

USE OF THE BUTTONS AND FUNCTIONS

The functions of the buttons described below are available only if they are on your original device.

Buttons for selecting the device to be
controlled.

Numeric keypad

Selects digital TV and radio

Volume control +/–

MUTE turns sound OFF and ON

For moving around within the MENU

TELETEXT buttons

Selects analogue/digital

Displays the list of programmes

Indicator Light

For selecting an external

input source

For selecting the next programme

P+ or the previous rogramme P–

Specifi c buttons for decoder

Fastext functions or for selecting sub-

ON/OFF switches the device OFF and

menus using colours

in some cases ON

6

INSERTING THE BATTERIES

Before using the remote control, insert the batteries and programme it.

Do not leave fl at batteries inserted, as liquid may leak and damage the remote control

SETTING CODES

SETTING CODES USING INTERNET

SETTING CODES USING A CELL PHONE

The remote control requires 2 new 1.5V alkaline AAA/LR03 batteries.
Insert them as illustrated.

Try pressing a number button and check that the red light remains lit continuously
until you release the button. If the light fl ashes, the batteries inserted are not charged
and are about to go fl at, therefore you must substitute them.

The Control 2 Digital remote control is a universal remote with a memory containing data regarding numerous devices
produced by different brands on the market.
Each original device has a specifi c code which must be used to set up the remote control.
So to use the Control 2 Digital you must enter the specifi c code for each device you wish to control.
So use one of the following methods to identify the correct code and set it in your remote control:

A) - INTERNET (recommended)
B) - CELL PHONE (SMS)
C) - MANUAL SEARCH

If you have an Internet connection available, follow the on-line guide on the www.cme.it website to identify the specifi c
codes for the devices you wish to command. Then set the codes manually in your CME remote control as described in the
ENTERING THE CODE DIRECTLY procedure.

(the service is free and the only cost is that of sending the SMS, which naturally depends on the rates of the service

Today, CME gives customers who don’t have internet the chance to receive the codes for programming their remote
control directly on their cell phone.
Simply send an SMS to this number 0039 345 7518893 as follows:

- [Type] = to indicate the device to be controlled using one of the following abbreviations: TV - SAT - TER (terrestrial
decoder).

- [Brand, Model] = to indicate the brand and the model of the device to be controlled.

Example: 2D, TV, PHILIPS, 32PFL3614 (if you don’t know the model, don’t write anything after the brand).

Once you have received the SMS with the list of codes, set the fi rst code in the remote control as described in the
ENTERING THE CODE DIRECTLY section.

operator in question)

2D, Type, Brand, Model

7