Meliconi AT38 LTE User Manual

2

3 1

AT 38 INDOOR AMPLIFIED ANTENNA

USER INSTRUCTIONS

The AT 38 MELICONI antenna receives and amplifi es digital terrestrial and analog TV
and radio signals on the VHF (band III) and UHF bands. To switch the device on and to
adjust amplifi cation turn the knob on the front.

GB

A

Make sure the appliances are switched off and the plugs are disconnected from

- Connect the antenna cable (1) to the socket at the back of the decoder or television.

- Connect the MELICONI antenna power supply cable (2) to a 230V~ /50Hz power
socket

- Turn the knob on the front in a clockwise direction to switch on the antenna and position
it at maximum amplifi cation. If the LED on the front lights up, it means the MELICONI
antenna is powered up correctly. At this point the antenna can receive television signals.

- Turn on the TV or decoder connected. To tune the channels follow the instructions
supplied with the appliance connected.
Note: it may be necessary to re-tune the channels.
When using the antenna on a boat or in a camper you can power the antenna via a DC
12 V 50 mA input (3) making sure that the poles indicated on the 12V input socket are
observed.

B

- Positioning the antenna: position the antenna near a window or outer wall, so it is poin­ting at the transmitter and is at a safe distance from metal objects, electrical equipment
(air conditioners, motors, ovens) and reinforced concrete walls which may disturb or limit
optimum reception.

- Turn or tilt the central ring antenna until optimum reception is obtained.

- Change the position, extension and direction of the style antennas located on the sides
(for the VHF).

- Adjust the level of amplifi cation by turning the knob on the front until the best possible
result is achieved.
Important: remember that maximum amplifi cation does not necessarily correspond to
optimum signal quality.

the supply sockets before making any connections

How to improve reception quality

Installation

3

C

- Keep away from water: the appliance should not be exposed to drips or water spray.
Do not use in a damp environment.

- he power supply plug must be easily accessible to enable the electric separation of
the device from the network.

- This product is for indoor use only: do not use in the open air

- This product is not a toy: keep out of the reach of children

- The product complies with directive 2011/65/CE concerning restrictions on the use of
hazardous substance (RoHS II) in electric and electronic equipment.

- The product complies with the new low voltage (LVD) directive 2006/95/EC, the EMC
directive 2004/108/CE and the ErP directive 2009/125/CE.

2 YEAR WARRANTY - The warranty is voided if the product is tampered with or used
improperly.

SPECIFICATIONS:

• Indoor amplifi ed antenna

• Reception of digital terrestrial TV signals (DVB-T), DAB radio signals and analogue
TV signals on UHF and VHF (band III) bands.

• Reception range: VHF + UHF (174 ~ 230 MHz 470 ~ 790 MHz)

• 4G LTE interference fi lter

• Amplifi cation adjustment: up to 38 dB

• Power supply AC 230V ~ 50 Hz or DC 12V
included)

• Consumption 3.5 W

• Output impedance: 75 Ohm

Warnings

50 mA (via an adaptor that is not

PACKAGE CONTENTS:

• Antenna

• Instruction booklet

When the symbol in question is applied to a product or packaging it indicates that the product should not be considered as
normal domestic waste, but should rather be disposed of at a suitable collection point for recycling electrical and electronic
appliances.
Disposing of this product correctly helps avoid any potential negative consequences that may derive from inappropriate
disposal. For more detailed information regarding product recycling, contact a relevant municipal offi ce, your local waste
disposal service or the owner of the store you bought the product from.

4