Meisida Electronic Toys 090727 User Manual

FOR AGE GROUP 8+

For more information, visit

www.1BADDRIDE.com

Operation Manual: Please read this manual carefully before operation. Please keep this manual for any needed future reference.

WARNINGS！WARNINGS！

Improper use of battery may lead to dangers such as heat, breakage
or leakage, Note the following items
Strictly observe the methods and cautions of the operation manual
Leakage from the battery may cause skin irritation. Recommendation is
to immediately and thoroughly cleanse the irritated area with soap and water.
Do not place battery into water or fire or puncture the battery.
Dispose of any exhausted batteries properly.
Leakage from the battery that has come in contact with the eye may cause
blindness. Cleanse the polluted eye immediately and consult doctor’s
advice on further treatment
Do not use, charge, or store batteries in places that are in close proximity

to fire, heat, or moisture.

years of age. As with all electrical products, precautions should be
observed during handling and used to reduce the risk of electric shock

--CAUTION ELECTRIC TOY

:

Not recommended for children under 8

CAUTIONS!CAUTIONS!

a.

M ke sure to switch off after play

-.

Non rechargeable batteries are not to be recharged
Rechargeable batteries are to be removed from the toy before charging.
Rechargeable batteries are only to be charged under adult supervision
Different types of batteries or new and used batteries are not to be mixed
as it may affect operation of the R/C.
Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the toy and disposed of
properly.
The supply terminals are not to be short circuited
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment
The toy is not to be connected to more than the recommended number
of power supplies
The antenna is not to be inserted into any light sockets or wall outlets.
This equipment has been tested and found to comply with the limits
for a Class B digital device pursuant to Part15 of the FCC Rules
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation
If this equipment does cause harmful interference to radio or television
which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the
following measures

Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from
that to which the receive is connected
Consult the dealer or an experienced radio TV technician for help.

.

.

-, .

,

:

-.

.

/

Method of Taking the Car out from the Foam.

1 Use a pair of scissors

.

to snip the string under
the foam. (See Illustration I.)

2 Take the Car out from

.

the foam. (See Illustration II.)

Illustration I

Illustration II

Loading & Unloading of the Battery of Remote Controller

1.Using 9V battery

2.Follow the arrow direction to remove the battery cover.

3.See below illustration. Install the 9V battery after checking
the positive and negative polarity, replace the battery cover.

4.The duration for continuous operation of the remote controller
battery is 8 hours.

.

.

.

,

.

Loading & Unloading of the Batteries of Toy Car

Main power switch

ON

OFF

1 Using x 1.5V AA alkaline

.

6

batteries.

2

.

Turn the switch “OFF”

3 See above illustration. Remove the battery cover by loosening screw,

.

install the 6pcs AAbatteries inside the battery grooves following the positive
and negative polarity as shown on each battery groove, replace the battery
cover over the battery compartment and affix the cover by re-tightening
the screw.

4 When theAA batteries are exhausted, Turn “OFF” the switch, loosen the

.

screw on the battery cover, remove the battery cover, take out the exhausted
AA batteries, and dispose of exhausted batteries properly. Reinstall new
AA batteries.

Remarks: 1. Don't connect the toy to the voltage which is higher than recommended.

2. Make sure the loading & unloading of the batteries of the toy car
is under adult supervision.

3. Remove batteries before storing car for extended period of time.

Indication for the Function of Remote Controller

Forward

Forward Left

Backward Left

Cautions:

1. The car runs in fast speed, please make sure to keep
others away to avoid crash or damage to car.

2. Make sure not to insert fingers or other objects into the gaps

between wheels & axles when playing to avoid any accidental injury.

Backward

Forward Right

Backward Right

Cautions in Operation

Caution: Don’t insert fingers or other objects
into the gaps between the wheel and car body.
Operation should only be performed under
close adult supervision. Don’t touch the
wheels or the front frame joining when the car

switch is turned “ON”.

Caution: Don’t brandish the antenna or point
the antenna toward anyone’s face as accidental

injury could occur in the event the antenna tip

went into the eye. Should the antenna be

damaged in any way, please be sure to replace
it due to the possibility of injury. Do not place
the antenna into any socket so as to avoid

electric shock.

© 2009 Professional Collectibles Ltd.

Made in China

Caution: Don’t play with the car on roads or
in crowded places to avoid accident or injury.
Also, don’t run the car on the restive places
such as a wet or sandy surface as this shall
lead to breakdown of the toy.

Warning:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.