D. Key Specifications /Special
Features Overall system
E. Receiver TYPE.2
F. Applications
3~4
5~6
6
7
8
8~11
* * * * * * * * * * * * *
-2--2-
A. Descriptions of Parts
Transmitter
+ UM-3"AA".5V
_
UM-3"AA".5V +
OPEN
(1) Antenna
(2) MIC. input
(3) Power switch
(4) LED indicator
(5) MIC. volume
(6) Battery cover
(7) Charging contart
(8) Battery box
(9) Channel selector
(10) Belt clip
_
SELECT
CHANNEL
SELECT
CHANNEL
-3--3-
Receiver
OPEN
+ UM-3"AA".5V
_
UM-3"AA".5V +
(1) Antenna
(2) EAR. input
(3) Power switch
(4) LED indicator
(5) EAR. volume
(6) Battery cover
(7) Charging contart
(8) Battery box
(9) Channel selector
(10) Belt clip
_
SELECT
CHANNEL
SELECT
CHANNEL
-4--4-
B. Features
1. Transmitter with built-in, hidden electrical
condenser mic. volume adjustable , applicable
with tie clip or head set microphone.
2. Receiver with built-in ,hidden super thin speaker ,
volume adjustable , applicable with ear set.
3.Match with HDC-202 intelligent charging stand ,
it allows over 10 hours operation after 4 hours
full charging. (Option)
-5--5-
4.Applicable Occasions : Tour Guide , Museum and
Factory visit, Oral multi-languages translating
system ,audio-visual language teaching , assist
wireless amplification system etc,
C. Transmitter
R F output
Battery life Ni-MH.
Rechargeable
Battery life
Alkaline disposable
Dimensions (L*W*H)
Weight with battery
10 mW
(according to regulation)
10 hours typical
17 hours typical
92*65*25 mm
128g
-6--6-
D. Key Specifications /Special
Features Overall system
Oscillation type
Carrier frequency range
Adjustable frequencies
Battery
Operating range
PLL synthesized control OSC
UHF 740~865 MHz
(according to regulation)
pre-programmed 8 or 16
switchable frequencies
1.2V (Ni-mh.1300mA)* 2 AA
rechargeable battery
1.5V * 2 AA
Alkaline disposable
>100M (opening field)
-7--7-
E. Receiver
Audio level
Earphone connector
Battery life Ni- MH.
Rechargeable
Battery life
Alkaline disposable
Dimensions (D*W*H)
Weight
0 dBvl
3.5mm jack socket, for mono
(built-in hidden speaker)
or stereo without speaker
9 hours typical
16 hours typical
92 * 65 * 25 mm
130g
F. Applications
1.Before use,please install the antenna and
batteries on transmitter and receiver .
-8--8-
2.Transmitter with built-in condenser mini mic.
or external microphone (Mic. jack).
Receiver with built-in mini spenker or external
earphone (earphone jack).
3.Move the power switch of transmitter to the "On"
position .The indicator lamp will flash red once
indicating power input properly.If the indicator
lamp stays red while the switch is on .it means the
power of batteries is low and the batteries need to
be recharged (when using with rechargeable battery)
or to be replaced (with dry cell batteries).
4.Move the power switch of receiver to the "On"
position.The green LED will light up indicates
receiving the signal from transmitter. When LED
stays red while switch is on, it means the power of
batteries is low.
-9--9-
5.Adjust the volume control switch both on
receiver and transmitter to proper volume.
6.Adjust both transmitter and receiver channel
(on back side) to the desired same channel
(0~F ch.). If the selected channel is noisy,
Adjust them to the other channel.
7.please keep the operntion distance more than
10~20M. between transmitter and receiver when
using with multi channel at same time to avoid
interference.
8.Please remove the batteries if the units will be out
of service for a long time, to avoid possible
damage due to leakage.
-10--10-
9.When recharging the transmitter and receiver
with charging stand ,please turn the switch to
"OFF" position and then insert in the charging
slot for recharging.(please use 2 pcs AA
size Ni-MH. Rechargeable battery)
10.This system also could use AA type dry battery,
but please do not put them on charging stand
for recharging.