MEGUIAR'S D151 User Manual

D151, Paint Reconditioning Cream (20-147D): D15101

__________________________________________________________________________________________

Page: 1 of 13

Safety Data Sheet

Copyright, 2012, Meguiar's, Inc. All rights reserved. Copying and/or downloading of this information for the purpose of
properly utilising Meguiar's, Inc. products is allowed provided that: (1) the information is copied in full with no changes
unless prior written agreement is obtained from Meguiar's, Inc., and (2) neither the copy nor the original is resold or otherwise
distributed with the intention of earning a profit thereon.

Document group:

26-6704-6

Version number:

1.02

Revision date:

20/04/2012

Supersedes date:

28/11/2011

Transportation version number: 1.00 (26/09/2011)

This Safety Data Sheet has been prepared in accordance with the REACH Regulation (EC) 1907/2006 and its modifications.

SECTION 1: Identification of the substance/mixture and of the
company/undertaking

1.1. Product identifier

D151, Paint Reconditioning Cream (20-147D): D15101

1.2. Relevant identified uses of the substance or mixture and uses advised against

Identified uses

Automotive.

1.3. Details of the supplier of the substance or mixture
Address:

Meguiars United Kingdon Limited, 3 Lamport Court, Heartlands, Daventry, Northants, NN11 8UF

Telephone:

[phone]

E Mail:

[e-mail]

Website:

www.meguiars.co.uk

1.4. Emergency telephone number

[phone]

SECTION 2: Hazard identification

2.1. Classification of the substance or mixture

Dangerous substances(67/548/EEC)/preparations(1999/45/EC) directive

This product is not classified as hazardous according to EU Directive 1999/45/EC.

2.2. Label elements

Dangerous substances(67/548/EEC)/preparations(1999/45/EC) directive

Symbols None.

Contains:

D151, Paint Reconditioning Cream (20-147D): D15101

__________________________________________________________________________________________

Page: 2 of 13

No ingredients are assigned to the label.

Risk phrases None.
Safety phrases

S23A Do not breathe vapour.
S24 Avoid contact with skin.
S62 If swallowed, do not induce vomiting: Seek medical advice immediately and show this container or

label.

Notes on labelling

R65 is not required on the label due to the product's viscosity.

Nota P applied to CASRN 64742-48-9. Nota N applied to CASRN 64742-46-7.

2.3. Other hazards

None known.

SECTION 3: Composition/information on ingredients

Ingredient CAS Nbr EU Inventory % by Wt Classification

Non hazardous ingredient Mixture 50 - 70
Naphtha (petroleum), hydrotreated heavy 64742-48-9 EINECS 265-

150-3

10 - 30 Xn:R65 - Nota 4,P (EU)

R66; R67 (Self Classified)

Asp. Tox. 1, H304 - Nota P
(CLP)
STOT SE 3, H336; EUH066

(Self Classified)
Aluminium oxide (REACH Reg. No.:01­2119529248-35)

1344-28-1 EINECS 215-

691-6

3 - 7

Distillates (petroleum), hydrotreated middle 64742-46-7 EINECS 265-

148-2

1 - 5 Nota N (EU)

Xn:R20-65; R66 (Self

Classified)

Nota N (CLP)

Acute Tox. 4, H332; Asp. Tox.

1, H304; STOT SE 3, H336;

EUH066 (Self Classified)
Siloxanes and silicones, di-Me 63148-62-9 1 - 5
Ceramic materials and wares, chemicals 66402-68-4 EINECS 266-

340-9

1 - 5

Conditioners Trade Secret 0.5 - 1.5
Quartz 14808-60-7 EINECS 238-

878-4

<= 0.04 Xn:R48/20 (Vendor)

STOT RE 1, H372 (Self

Classified)

Please see section 16 for the full text of any R phrases and H statements referred to in this section
Please refer to section 15 for the any applicable Notas that have been applied to the above components

For information on ingredient occupational exposure limits or PBT or vPvB status, see sections 8 and 12 of this SDS

SECTION 4: First aid measures

4.1. Description of first aid measures

D151, Paint Reconditioning Cream (20-147D): D15101

__________________________________________________________________________________________

Page: 3 of 13

Eye contact

Flush with large amounts of water. Remove contact lenses if easy to do. Continue rinsing. If signs/symptoms persist, get
medical attention.

Skin contact

Wash with soap and water. If signs/symptoms develop, get medical attention.

Inhalation

Remove person to fresh air. If you feel unwell, get medical attention.

If swallowed

Rinse mouth. If you feel unwell, get medical attention.

4.2. Most important symptoms and effects, both acute and delayed

See Section 11.1 Information on toxicological effects

4.3. Indication of any immediate medical attention and special treatment required

Not applicable

SECTION 5: Fire-fighting measures

5.1. Extinguishing media

In case of fire: Use a fire fighting agent suitable for ordinary combustible material such as water or foam.

5.2. Special hazards arising from the substance or mixture

None inherent in this product.

Hazardous Decomposition or By-Products

Substance Condition

Formaldehyde During combustion.
Carbon monoxide. During combustion.
Carbon dioxide. During combustion.
Irritant vapours or gases. During combustion.

5.3. Advice for fire-fighters

No unusual fire or explosion hazards are anticipated.

SECTION 6: Accidental release measures

6.1. Personal precautions, protective equipment and emergency procedures

Ventilate the area with fresh air. For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or
exhaust vapours, in accordance with good industrial hygiene practice. Warning: A motor could be an ignition source and
could cause flammable gases or vapours in the spill area to burn or explode. Refer to other sections of this SDS for
information regarding physical and health hazards, respiratory protection, ventilation, and personal protective equipment.

6.2. Environmental precautions

Avoid release to the environment.

6.3. Methods and material for containment and cleaning up

Contain spill. Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially
available inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Remember, adding an absorbent
material does not remove a toxic, corrosivity or flammability hazard. Collect as much of the spilled material as possible.
Clean up residue with detergent and water. Place in a closed container approved for transportation by appropriate authorities.

D151, Paint Reconditioning Cream (20-147D): D15101

__________________________________________________________________________________________

Page: 4 of 13

Seal the container. Dispose of collected material as soon as possible.

6.4. Reference to other sections

Refer to Section 8 and Section 13 for more information

SECTION 7: Handling and storage

7.1. Precautions for safe handling

Keep out of reach of children. Do not handle until all safety precautions have been read and understood. Do not get in eyes,
on skin, or on clothing. Do not breathe dust/fume/gas/mist/vapours/spray. Avoid breathing of dust created by cutting,
sanding, grinding or machining. Do not use in a confined area or areas with little or no air movement. Use personal
protective equipment (eg. gloves, respirators…) as required. Avoid contact with oxidising agents (eg. chlorine, chromic acid
etc.) Do not eat, drink or smoke when using this product. Wash thoroughly after handling.

7.2. Conditions for safe storage including any incompatibilities

Store away from acids. Store away from heat. Store away from oxidising agents.

7.3. Specific end use(s)

See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.

SECTION 8: Exposure controls/personal protection

8.1 Control parameters

Occupational exposure limits

Ingredient CAS Nbr Agency Limit type Additional comments

Aluminium oxide 1344-28-1 Health and

Safety Comm.
(UK)

TWA(as inhalable dust):10
mg/m³;TWA(as respirable

dust):4 mg/m³
Silica, crystalline (airborne
particles of respirable size)

14808-60-7 Health and

Safety Comm.
(UK)

TWA(respirable):0.1 mg/m3

Naphtha (petroleum),
hydrotreated heavy

64742-48-9 Manufacturer

determined

TWA:100 ppm

Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling

8.2. Exposure controls

8.2.1. Engineering controls

Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.

8.2.2. Personal protective equipment (PPE)

Eye/face protection

The following eye protection(s) are recommended: Safety glasses with side shields.

Skin/hand protection