D108, Super Degreaser (22-160A): D10801, D10805, D10855
__________________________________________________________________________________________
Page: 5 of 15
No unusual fire or explosion hazards are anticipated.
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Evacuate area. Ventilate the area with fresh air. For large spill, or spills in confined spaces, provide mechanical ventilation
to disperse or exhaust vapours, in accordance with good industrial hygiene practice. Warning: A motor could be an ignition
source and could cause flammable gases or vapours in the spill area to burn or explode. Refer to other sections of this SDS
for information regarding physical and health hazards, respiratory protection, ventilation, and personal protective equipment.
6.2. Environmental precautions
Avoid release to the environment. For larger spills, cover drains and build dykes to prevent entry into sewer systems or
bodies of water.
6.3. Methods and material for containment and cleaning up
Contain spill. For large spills, if necessary, get assistance from professional spill clean up team. For small spills, carefully
neutralise spill by adding appropriate dilute acid such as vinegar. Work slowly to avoid boiling or spattering. Continue to add
neutralising agent until reaction stops. Let cool before collecting. Working from around the edges of the spill inward, cover
with bentonite, vermiculite, or commercially available inorganic absorbent material. Mix in sufficient absorbent until it
appears dry. Absorb spillage to prevent material damage. Remember, adding an absorbent material does not remove a
physical, health, or environmental hazard. Collect as much of the spilled material as possible. Place in a metal container
approved for use in transportation by appropriate authorities. The container must be lined with polyethylene plastic or contain
a plastic drum liner made of polyethylene. Clean up residue with water. Cover, but do not seal for 48 hours. Dispose of
collected material as soon as possible.
6.4. Reference to other sections
Refer to Section 8 and Section 13 for more information
SECTION 7: Handling and storage
7.1. Precautions for safe handling
For industrial or professional use only. Do not breathe dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on
clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Wash contaminated clothing
before reuse. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.) Keep away from reactive metals (eg.
Aluminum, zinc etc.) to avoid the formation of hydrogen gas that could create an explosion hazard.
7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Keep container tightly closed. Keep only in original container. Store in a corrosive resistant
container with a resistant inner liner. Store away from acids. Store away from oxidising agents.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
Potassium Hydroxide 1310-58-3 Health and
Safety Comm.
(UK)
STEL:2 mg/m3
Health and Safety Comm. (UK) : UK Health and Safety Commission