Page 1
CP1100
KEYLESS ENTRY SYSTEM
INSTALLATION & OPERATION INSTRUCTIONS
REMOTE
CONTROL
Button Step Functions Mode
1
Press once
Press once
a. Lock Doors
b. Unlock doors
a. Acc off
2
Press one time
Press and hold 2 sec.
a. Disarm & unlock doors
b. (disarm) optional trun
k
release or aux.function
a. Armed
b. Ign. off
1+2 Press 1 and 2 together Panic (optional siren) Anytime
FEATURES
C
ODE LEARNING
a. Turn ACC OFF/ON ( OFF then ON as one cycle) 8 cycles and stay at ACC ON
within 10 seconds. Siren will chirp 3 times to enter code learning. Then press
any button on the remote control within 10 seconds.
b. If a new remote control is to be programmed, all existing remote controls must
be reprogrammed at the same time. Up to 3 remote controls can be
programmed.
LOCKING/A
RMING
a. Press button 1.
b. Siren will chirp 1 time.
c. Parking light will flash once.
d. Doors locked at 0.5sec or 3.5 sec (See Jumper Selection J1).
e. LED will flash slowly.
f. Disables engine starter (if relay connected).
UNLOCKING/D
ISARMING
a. Press button 1.
b. Siren will chirp 3 times.
c. Parking lights will flash 3 times.
d. Doors will be unlocked at 0.5sec or 3.5sec.
e. Enables engine (if kill starter relay connected).
E
MERGENCY DISARMING - OVERRIDE
a. In armed mode, if the remote control failed or lost, insert the ignition key and
turn the IGNITION ‘OFF/ON’ (Off then ON as a cycle) for 5 times and
leave it ‘ON’, within 10 sec.
b. The optional siren will sound 4 times and the system disarmed. This process
must be finished within 10 seconds.
P
ANIC
a. Press button 1+2, the optional siren will sound, and parking lights will flash for
30 seconds.
b. Pressing button 1or 2 will stop the panic.
C
AR FINDER
a. Alarm in locked/armed mode.
b. Press button 2: the optional siren will sound once and parking lights will flash 10
times.
c. Press button 2 : car finder in silent mode ( parking lights will flash 10 times
but without siren sound )
d. Press button 1 to stop it.
OPEN TRUNK
In unlocked/disarmed and ignition OFF mode: press buttons 2 hold 2 sec to
open trunk.
V
ALET
a. When IGN ‘ON’, Turn the IGN. ‘OFF/ON’ (OFF then ON as one cycle) 3 cycles
and stay at IGN ‘ON’, within 8 sec.
b. Enter valet mode, LED will be constantly ON even when the IGN is ‘OFF’.
c. In valet mode, siren chirps twice and parking lights will flash twice when
locked/armed.
d. Disable valet mode: When IGN ‘ON’, Turn IGN ‘OFF/ON’ (OFF then ON as
one cycle) 3 cycles. Then the LED will be OFF after 8 sec.
A
UTOMATIC REARMING
1
2
When the alarm is disarmed, if the ACC is not turned ON or doors not opened,
after 30sec the alarm will automatically be rearmed.
A
UTO LOCK/UNLOCK
a. Turn the ignition OFF; the door unlocks automatically.
b. Turn the ignition ON; the door locks automatically after 10 sec.
Note: 1. Turn ignition ON while door is open, the auto lock is invalid.
2. Auto lock is invalid if any door is opened during the 10 sec of
countdown of Auto lock function.
MEMORY FUNCTION
The Alarm will memorize the condition when the power is cut off.
FUNCTION
SELECTION
There are four jumper selections (J1~J4). See the table below.
Important: All jumper selections have to be determined before installation.
Otherwise, you have to power off the module again to reset.
JUMPER MODE FUNCTION MODE FUNCTION
J1: LOCK TIMER
0.5 SEC 3.5 SEC
J2: AUTO LOCK/UNLOCK
YES
NO
J3: ANTI CAR-JACKING
YES NO
J4: LAST DOOR ARMING
WITH DOOR LOCK
NO
YES
OPERATION INDICATORS
LED STATUS
a. LOCKED/ARMED: LED flashes slowly as 1 time per sec.
b. Re-arming mode: LED flashes quickly.
c. Valet mode: LED ON constantly.
REV: B1002
Page 2
TRUNK
OPTIONAL
+12V
J1 J2 J3 J4
INSTALLATION GUIDE
MODEL: CP1125
OPTIONAL SIREN
START MOTOR
RELAY
PIN 86
12V
BATTERY
PIN 85
FUSE 15A
RELAY
ORANGE
OW
BROW
WHITE
N
GRAY
YELL
BLACK
RED
FUSE 10A
PARKING LIGHTS
OPTIONAL
FUSE BOX
ACC
OFF
START
ON
LED
PIN 87a
30
IGNITION
STARTER
KILL
LOCK(-200mA)
UNLOCK(-200mA)
GREEN/WHITE
BLUE/WHITE
Loading...