MegaTech MTC 8112, MTC 8114, MTC 8113 Instruction Manual

Entire contents © Megatech 2002

www.megatech.com

MTC 8112 - Capitol Flyer
MTC 8113 - Skyliner
MTC 8114 - Airstike

Instruction Manual

Learn the basics of Aerodynamics with Megatech’s Fun

Flight Series Free Flight Airplanes! This Rechargeable

Electric powered Cessna style airplane is perfect for

introducing kids into the exciting world of aviation. The unique

break-away wing design allows the free ight to be own

again and again even after a crash landing!

General Safety

1 Always y in an open area far from streets, power lines or
trees.

1 Do not y in winds over 5MPH

1 Have all spectators stand clear when launching

and ying the airplane

Battery Safety

The free-ight’s on-board battery is made of the latest
technology in Nickel-cadmium batteries. Special safety
precautions MUST be observed to prevent injury to yourself
or damage to the battery pack.

1 NEVER charge the battery pack for longer than 2
minutes

1 DO NOT allow smoking, sparks or an open ame near the
while charging.

1 ALWAYS charge the battery in a well ventilated area

1 DO NOT incinerate or alter the battery, doing so may

result in the battery bursting and releasing toxic
materials.

1 If battery pack gets very hot or makes a popping sound
or leaks a liquid during the charging process---STOP
CHARGING IMMEDIATELY, the pack has overheated
and will be damaged by further use.

Propeller Safety

The free ight has a high-speed performance propeller and
adult supervision is required during use.

1 Do not alter your propeller, discard worn or damaged
propellers.

1 Keep ngers, face and all loose objects away from
spinning propeller

1 Only use propellers approved for use with this free ight
airplane

1. Getting Acquainted with your Free Flight

Before you begin, make sure the contents are complete:

1.Airplane Fuselage

2.Main Wing & Tail Wing set

3.Charger

4.Propellers (2)

5.Wing Supports

6.Landing Gear

7.Wing Brace

1

2

2

7

4

6

5

3

2

2. Attaching the Main Wing & Wing Supports

1 First lay the 2 halves of the main wing
next to each other with the double
sided tape facing up

1 Find the 2 at wing supports
(non-bent)

1 Remove the protective paper from the
double sided tape on both pieces of
the main wing

1 Push peg through indented circle as
shown and align the wing support
with the tape as shown (peg should
push through to under side of the
main wing)

1 Remove protective paper from double
sided tape on top of the fuselage

1 Center main wing pieces as
shown, making sure the pegs are
facing downwards and the decals are
positioned towards the front of the
plane.