Page 1
QUICK START GUIDE
- mPulzer
- This Quick Start Guide.
- May explode if dispose in fire.
- Do not attempt to open or disassemble the unit.
mPulzer (BLE Temperature Logger)
PZ1D-MB / PZ1S-MB
What ships in the box
Important Safety instructions
Product outlook
Product description
mPulzer is a Bluetooth BLE temperature logger. It equips with two temperature probes.
The internal probe is fixed and the external probe is around 1 meter long. The temperature
information will be broadcasted through the standard Bluetooth Low Energy communication
channels.
Item Specification
Battery 2400mAh non-rechargeable lithium battery
Bluetooth Bluetooth BLE
Operation temp. -40 to +85 deg C
Page 2
mPulzer body
- Red
- Green
Items
no.
1 LED indication Bi-color LED
2 Function Key Functional key to activate the device
3 Internal Probe Internal NTC probe
4 External Probe 1m long NTC probe
Name Description
CAUTION:
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
REGULATORY CONFORMANCE
Hereby, Megabyte Limited declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU.
For the declaration of conformity, visit the address: Unit 301-302, 3/F, Building 12W, No. 12
Science Park West Avenue, Hong Kong Science Park, Shatin, New Territories, Hong Kong.
Notice: Observe the national local regulations in the location where the device is to be used.
This device may be restricted for use in some or all member states of the European Union.
Page 3
FCC Statement
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help
CE statement
CE NOTICE:
The CE Mark applies to products regulated by certain European health, safety and
environmental protection legislation. The CE Mark is obligatory for products it applies to: the
manufacturer affixes the marking in order to be allowed to sell his product in the European
market.
RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Technical support
Technical support can be obtained from Megasoft Limited.
Address: Unit 301/302, 3/F, Building 12W, No. 12 Science Park West Avenue,
Hong Kong Science Park, Shatin, New Territories, Hong Kong.
Loading...