Mega Accy M1300 User Manual

M1300

Bluetooth Headset
User Guide

Power On

Power Off

No pairing
with phone

Low Volume

Noise
phone.

for more than 1 second.

manual for more information.

additional pairing in the next time.

manual.

Your phone should support voice dial
call function. Please see your phone

headset.

to phone, please refer to your phone

follow directions.

Weight

Pairing with phone

Transfer Call

2. When you transfer call from headset

press "OK"button on the phone.

5. Enter "0000" (4 zeros) and

p

ress OK

6. Once pairing is completed
successfull

y,

there will be no need f

o

2. Press and hold volume(+) button for

Answering a Call

Ending a Call

Last Number Redialing

Call Rejection

sound.

When

y

ou have incomming call and you

hear the rin

g

sound, press the call butto

n

Press call button shortly until you hear
command from the phone, and then

3. Perform Bluetooth connection with

4. When M1300 appears in the phone,

the phone.

call button for up to 4 seconds.

To turn off M1300, press and hold the

on the front for about 1-3 seconds .

You must pair your headset with phone
before you make a call.

1. Press the call button for power on.

on steadily.

about 4 seconds until the LED turns

To turn on M1300, press the call button

Charging Bluetooth

Charge M1300 fully, before using it.

1. Insert adaptor into charger jack on
the left side of headset.

2. Insert ada

p

tor into an electrical outle

t

3. M1300 will be fully charged within 2
hours.

Headset Features Start using headset

Average 6 hrs

Average 170 hrs

How to pair

1. When you transfer call from phone to

DESCRIPTIONITEMITEM

Call Time

-20 ~ 60 ‘C

120mAh , 3.7V

Approx.

18.4 x 45.7 x 12.8mm

Approx.

9.2 g (0.33 oz)

Specifications

Bluetooth Version V 1.2

Handsfree Profile

Profile

Headset Profile

-Stay within 30 ft from your

-Adjust volume of headset

Standby Time

Upto 10m (30 feet)

Operating Temp.

-Check pin code "0000"

or phone.

Call Distance

Size (W x L x H)

Battery

How to call

-Check pairing order of

DESCRIPTION

-Check wheather headset
is at pairing mode.

When

y

ou receive a call, press call butt

o

Troubleshooting

shortly.

Transfer Call/Adj.Volume

headset, press call button of the

Make a Voice Dial Call

phone

shortly.

Press call button until you hear beep

When you finish a call, press call button

Adjust Volume

Press volume (+/-) button.

(+)

Call Button

(-)

LED
Indicator

Charger Jack

Receiver

MIC

Volume
Button

<<NOTICE>>
* Section 15.19 Labellin

g requirements

This device complies with part 15 of the FCC rules
O

peration is subject to the following two conditions:

(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause

undesired o

peration.

* Section 15.21 Information to user

The changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authorit

y to operate the equipment.

* IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna

or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF
exposure requirements and void user’s authority to operate the device.

FCC ID URMBCM110