MEE AF32 User Manual

STEREO BLUETOOTH

®

WIRELESS HEADPHONES

model: AF32

USER MANUAL

part of the series

PACKAGE CONTENTS

1

Runaway AF32
Stereo Bluetooth
Wireless Headphones

Charging cable
(USB – 3.5mm)

Stereo audio cable
(3.5mm – 3.5mm)

Carrying pouch

User manual

PRODUCT OVERVIEW

Stereo Bluetooth
Wireless Headphones

RIGHT EAR CUP

LED indicator light

A

Multifunction button ( / )

B

Previous track button ( )

C

Next track button ( )

D

Volume down button ( )

E

Volume up button ( )

F

Headphone / charging jack

G

Microphone

H

-

+

2

CHARGING

*** You must completely charge the headphone before the first use ***

Connect the USB charging cable to any powered USB port and to the 3.5mm
jack on the right earcup. Make sure it is plugged in fully. Charge time is
typically 2-3 hours.

The red LED light will stay lit while the headphones are charging and will blink
or turn off completely when the headphones are ready for use. A blinking red
LED light indicates a trickle charge mode, whereby the battery is charged
almost fully and the headphones are maintaining their current charge level.

Note: the Runaway cannot be turned on or used while charging.

INDICATOR LIGHT STATE WHEN CHARGING CABLE IS PLUGGED IN:

LIGHT PATTERN STATUS NOTES

Solid red light Battery charging Allow to charge for 2-3 hours

Blinking red light Trickle charge Ready for use

All lights off Battery full Ready for use

When the battery is low, the headphones will say “Battery low” every
60 seconds and the red light will flash three times every three seconds.

Apple devices such as the iPhone®, iPad®, and iPod® Touch will display a
headphone battery indicator when the Runaway is connected.

3

TURNING ON AND OFF

To turn on, press and hold the Multifunction button for approximately 3
seconds. The headphones will say “Power on” and the blue LED light will flash.

To turn off, press and hold the Multifunction button for approximately 4
seconds. The headphones will say “Power off” and the red LED light will flash.

PAIRING WITH BLUETOOTH DEVICES

*** Your headphones must be paired to a Bluetooth device before it can be

used. It is only necessary to pair your headphones once with each device. ***

1) Open the Bluetooth menu on the device you wish to pair (see Locating
the Bluetooth Menu on page 5 for more details). Some devices require

you to select “Search for Devices” or “Add New Device” in order to create a
Bluetooth pairing.

2) With the headphones turned off, press and hold the Multifunction button for
approximately 6 seconds until the headphones say “Pairing”. The red and
blue LED lights will flash in an alternating pattern while the Runaway is in
pairing mode. (Note: The Runaway will enter standby mode if not paired
within 90 seconds.)

3) Wait until you see “Air-Fi Runaway” on your device screen.

4) Select “Air-Fi Runaway” on your device and follow any further prompts
to pair. Use “0000” if a pin is required. Once pairing is complete and a
connection is established, the blue LED light will flash several times.

4