MEDTOX SURE-SCREEN Quick Reference Manual

SURE-SCREEN

®

Quick Reference Guide

The device detects one or more of the following
drug classes at the following concentrations:

Amphetamine (AMP)

300 ng/ml

Barbiturates (BAR)

200 ng/ml

Buprenorphine (BUP)

10 ng/ml

Benzodiazepines (BZO)

200 ng/ml

Cocaine (COC)

100 ng/ml

Methadone (MTD)

200 ng/ml

Methamphetamine (mAMP)

1000 ng/ml

Opiates (OPI)

100 ng/ml

Oxycodone (OXY)

100 ng/ml

Phencyclidine (PCP)

25 ng/ml

Propoxyphene (PPX)

300 ng/ml

Cannabinoids (THC)

40 ng/ml

Note: If LFAS adulterant strip is present (to the right of drug test strips),
refer to the Color Comparator Chart to interpret results.

Obtain urine. Urine level
must be between the Min /
Max lines on cup. If urine
was refrigerated, bring to
room temp and mix well
before testing.

Screw lid onto cup --

TIGHTEN FIRMLY.

Tear open pouch and
remove device. Align device
and cup as shown.

Place the device securely on
to the lid---the parts should
interlock easily and move
freely clockwise.

Rotate the device clockwise
¼ of a turn (i.e. from 9
o’clock to 12 o’clock) until it
snaps into place.

Place cup on its side as
shown above to start urine
flow.

For examples at right:

C = Control
T1 Tests = AMP, THC, BZO
T2 Tests = COC, OPI

VALID:

A reddish-purple line appears
in the “C” area for each test.

Example Sufficient URINE Present

--about ¼ inch evenly distributed--
is all that is needed for the device to
migrate properly. More urine is NOT
necessary! Allow test device to rest
undisturbed for 5 minutes.

INVALID:

No control line “C” present.
Retest urine with a new
device.

NEGATIVE:

Any reddish-purple line visible at 5 min.
in the test area is a negative result
(even a faint or broken line).

Example above: all 5 test results are
negative.

PRELIMINARY POSITIVE:

The absence of a line in the test area
is a preliminary positive result.

Example above: the AMP
(Amphetamine) test is a preliminary
positive.

Seal Properly if
Transporting to Laboratory
for confirmation:

 Tighten the lid
 Use dual seal provided

with cup

o Seal sample port
o Seal vent hole

For complete product information refer to the PACKAGE

INSERT available at http://www.medtox.com/ProductTraining.aspx

or contact Technical Support at 1-877-643-5703.

SURE-SCREEN

®

12-panel Forensic Use Only Package

INSERT Rev. 6/10, P/N 102109.

MEDTOX Diagnostics, Inc. • 1238 Anthony Road

Burlington, NC 27215

Phone: [phone] • Fax: [phone]

E-mail: [e-mail]

READING THE TEST RESULTS
Read Time: 5 minutes

C = Control Line
T1 = Test Line for drug

name on top portion

T2 = Test Line for drug

name below
(if no print on lower
color, then no T2
drug tested)

Bring pouched device to
room temp (18-25°C / 64­77°F) before opening.

For Forensic Use Only

Instructions

Strips with two tests will be labeled with two colors. The top color will indicate the T1 test with drug test name=T1. The bottom
color will indicate the T2 test with test name=T2. Strips with only one color will have test results appear at the T1 position only.

© 2010 MEDTOX Diagnostics, Inc. All rights reserved. P/N: 102113 Rev. 8/10