Page 1
Mode Button
• Turn monitor ON and OFF
• Access monitor setup options and memory
(settings, previous results and averages)
Forward and Back Button
• Select monitor settings
• Review monitor settings and memory
(results and averages)
Setup Options
• Beeper, time, date and measurement units
(mmol/L or mg/dL)
MediSense, Optium and Xceed are trademarks of Abbott
Laboratories. ©2004 Abbott Laboratories.
P/N 133-224 Rev. 0 5/04
Back
Button
Backlight
Button
Display Window
Electrode Port
Mode
Button
Forward
Button
Features
Reorder No.:70314-01
Diabetes Monitoring System
Quick Reference Guide
Slug Does Not Print On Final- For Labelling Production Use Only
Part Number 133-224
Rev # 0
Creative #
Date Open 15 Apr 04
LCN# C Target Prep
Last Edited 11 May 04
MAC
PROD
TRAF
A/S
A/D
ORIG
FOLD FOLD FOLD
FOLD FOLD FOLD
These instructions are intended as a quick reference
guide only. For complete operating instructions and
other important product information, refer to the
Optium
TM
XceedTMUser’s Guide and the MediSense
®
OptiumTMBlood Glucose and MediSense®Optium
TM
Ketone Blood β-Ketone Electrode instructions for use.
Customer Support
Australia: 1 800 801 478
New Zealand: 0800 106 100
Abbott Diagnostics Division, MediSense Products,
666 Doncaster Road, Doncaster 3108, Victoria, Australia
133-224 Guide,Quick Ref,AUS 5/13/04 10:54 AM Page 1
Page 2
FOLD FOLD FOLD
FOLD FOLD FOLD
1
Open the calibrator package (in new box
of electrodes). Find the three raised bumps
on the calibrator package. Peel the clear
cover away from the bumps.
Impor
tant: Failure to calibrate
properly will cause incorrect results.
2
Hold the calibrator with the LOT
number facing you.
3
Insert the calibrator into the electrode port.
Push it in until it stops. The LOT number
shows on the display window with the
time and date.
4
Check that the LOT numbers on all these items match:
Display window
Electrode calibrator
Electrode instructions for use
Electrode foil packet
Blood Glucose Calibration Steps
Blood Glucose Monitoring Steps
1
Insert the three black lines at the end
of the electrode into the electrode port
until it stops. The monitor turns on
automatically. The Apply Blood symbol
and LOT number appear on the
display screen.
2
Check that the LOT number on the
screen matches the batch of electrodes
being used. Touch the blood drop to
the white area at the end of the
electrode.
3
Continue to touch the blood
to the end of the electrode
until the test begins.
4
Accurate results
in seconds.
133-224 Guide,Quick Ref,AUS 5/13/04 10:54 AM Page 2
Loading...