media-tech MT4165 U-Screen Lite User Manual

User Manual
U-SCREEN LITE
HD TERRESTRIAL DIGITAL TV RECEIVER & PLAYER
MT4165
2
EN
Index
Front panel.....................................................................................2
Rear panel ...................................................................................... 2
Remote ...........................................................................................3
Control .............................................................................................3
Installing the Batteries ...............................................................4
Using the Remote Control ........................................................4
Connections .................................................................................. 4
First Time Installation ................................................................. 5
SETUP&MORE................................................................................6
Setup/Installation ........................................................................6
BROADCASTING – TV, Radio and Recorder. ....................... 7
MULTIMEDIA..................................................................................8
NAVI Bar .......................................................................................... 8
TimeShift ......................................................................................10
Troubleshooting ........................................................................11
Front panel
Rear panel
1. STANDBY INDICATOR: the green LED will be light if turned on, and the red LED in standby mode.
2. REMOTE CONTROL SENSOR: to receive the signal from the remote control.
3. USB Port: to connect to an external USB 2.0 device.
1. RF IN
2. COAXIAL
3. HDMI OUT
4. SCART OUT
5. DC IN 5V
Note! There is no video output from scart if the HDMI output is connected to TV. Note! If an external hard disk is connected to the USB port, suggest to use the adapter which supply DC5V/2A that is not provided.
1
2
3 4 5
2
3
1
3
EN
1. LIST – Show recorder list.
2. MUTE – Enable/disable mute.
3. INFO – Show/Hide service info.
4. TTX – Enter/exit teletext menu.
5. SUBTITLE – Enter/exit subtitle menu.
6. EXIT/*NAVI – Exit current menu.
7. OK – Select/confi rm key.
8. LEFT/RIGHT – Volume down / arrow
left / Volume up / arrow right.
9. TV/RADIO –Switch between TV/Radio channels.
10. RECALL – Recall to last watching channel.
11. GOTO – Jump to specifi c time in multimedia mode.
12. PREV – Play previous.
13. NEXT – Play next.
14. REPEAT – Repeat.
15. STOP – Stop recording / stop play.
16. REC – Start to record current
TV/Radio channel.
17. POWER – Enter or leave standby mode.
18. EPG – Enter EPG.
19. AUDIO – Enter audio setting menu.
20. UP/DOWN - Channel up / arrow up /
Channel down / arrow down
21. MENU – Enter main menu.
22. FAVOURITE – Favorite programs.
23. Digital input.
24. FWD – Play fast forward with x2,
x4, x8, x16 and x32 times of speed.
25. REV – Play fast backward with x2, x4, x8, x16 and x32 times of speed.
26. PLAY – Resume current play from pause.
27. PAUSE – Pause current play.
28. RED/GREEN/YELLOW/BLUE
*NAVI – NAVI bar is available when EXIT
button is pressed in EPG, TTX, AUDIO or SUBTITLE menu.
Remote Control
4
EN
Installing the Batteries
Using the Remote Control
The Remote Control has a range of up to 7 metres from the Set Top Box at an angle of up to 60 degrees.
Put 2xAAA size batteries inside the compartment. The diagram inside the Battery Compartment shows the correct way to install the batteries
1. Open the cover 2. Install batteries 3. Close the cover
Connections
Loading...
+ 8 hidden pages