media-tech MT1503 User Manual

ROGUE RF

Wireless Gamepad PC with headphones connection

MT1503

User’s Guide (revised edition)

Thank you for purchasing ROGUE RF MT1503 wireless controller with headphones connection. This user’s guide
will help you understand how to use your gamepad and get the most from the features it has to offer.

Package Contents

1. ROGUE RF MT1503 gamepad

2. RF receiver

3. Driver disc

4. User’s guide

NOTE: AA batteries are not included

Software Installation

Insert DRIVER CD into computer driver and then proceed follow the steps:

Hardware Setup

1. Connect receiver to USB port in the
Computer

2. Insert 2 AA alkaline batteries follow
polarization (+/-) Marks

3. Switch ON the gamepad using ON/OFF
Switch

4. Connection is confirmed when green LED
stop blinking

5. Open Start > Control Panel > Game Controllers
window, mark 1st controller and click “Properties”.

6. Test gamepad features

Note: Use only alkaline or Ni-MH rechargeable
battery.

Hardware Recognition

GAMEPAD

1. Direction cross

2. Analog sticks with buttons

3. Digital buttons

4. Analog buttons

5. MODE button

6. VIBRATION ON/OFF button

7. TURBO button

8. CLEAR button

9. Headphones sockets (green for sound, pin for microphone)

10. ON/OFF switch

1

5 6 8 7

4

3

9

2

10

12 11

RECEIVER

11. Power LED (red)

12. Activity LED (green)

Gamepad Using

Changing working modes

The ROGUE RF MT1503 supports two control
modes: analog and digital.

1. Push MODE button (red light on the button)
– gamepad turned to analog mode

2. Push MODE button again (no light on button)
– gamepad is turned to digital mode

Turbo-fire Function

MT1503 is equipped with programmed turbo-fire feature for every of digital action buttons.

1. To enable this feature, please press simultaneously action button and TURBO button (ex. 3 + TURBO).

2. To disable turbo-fire feature for specific button press this combination once again.

Connecting Headphones

MT1503 has possibility to connect headphones with microphone for team-playing games.

1. Connect headphones and microphone jacks to desired sockets in gamepad

2. In Control Panel make sure that “USB AUDIO+GAME” device in recording and playback section is set as
default device.

Using with Sony Playstation® III

Note that when plugged to Playstation III in analog mode only one analog button is active (right). Note also
different Playstation control buttons located on MT1503 (see picture below), other buttons are located and
working as Sony original controller.

Troubleshooting

Problem: The unit does not respond, the red LED on the receiver is OFF.
Solution: Connection between the receiver and the computer is not good. Insert the receiver to the USB port firmly.

Problem: The unit does not respond, the green LED on the receiver is blinking.
Solution: Replace new battery for the controller.

Problem: The accessible distance of the unit from the computer is getting shorter.
Solution: Replace new battery for the controller.

Problem: my controller do not support vibration function.
Solution: Some game software will not support the vibration function. See game manual for detail instructions.
Solution: the driver is not working well. Reinstall the driver.

Problem: I don’t have sound in connected to gamepad headphones, microphone is not working.
Solution: Make sure that You connected right plugs to sockets in gamepad. In Control Panel make sure that “USB AUDIO+GAME” device in

recording and playback section is set as default device

Problem: Sound quality is worse than in headphones connected directly to the computer.
Solution: Everything is correct. Quality of sound will be worse because is compressed and must be transmitted by air together with gaming data

from gamepad.

NOTE. For gamepad configuration in games please read desired game manual.