MT1416 COLIBER BT
User’s manual – revised version
Installation under Windows XP using system Bluetooth software
Installation
1. Open battery compartment located on the bottom of keyboard. Install 2xAAA batteries, please note
polarization marks. Turn ON/OFF switch into ON position.
2. Now press ID button for about 1 sec. Keyboard will switch into “pairing mode”, NumLock LED will flash to
indicate this status.
3. Make sure that your Bluetooth interface in your PC computer is active. Right click Bluetooth icon and select
“Add Bluetooth Device”.
4. Now tag “My device is set up and ready to be found” and click “next”.
5. Select “Bluetooth keyboard” and click “next”.
6. Select option “choose a passkey for me” and click “next”.
7. Now enter generated passkey using Bluetooth keyboard and press ENTER to send code.
8. Click “finish” to end pairing process. NumLock LED on the Bluetooth keyboard should be off now indicating
successful connection.
9. Now you can use your Bluetooth keyboard with touchpad. When you turn OFF and again turn ON keyboard
or PC computer connection will be established automatically.
Installation under Windows7 using system Bluetooth software
Installation
1. Open battery compartment located on the bottom of keyboard. Install 2xAAA batteries, please note
polarization marks. Turn ON/OFF switch into ON position.
2. Now press ID button for about 1 sec. Keyboard will switch into “pairing mode”, NumLock LED will flash to
indicate this status.
3. Make sure that your Bluetooth interface in your PC computer is active. Right click Bluetooth icon and select
“Add Bluetooth Device”.
4. An error message will occur click “Try again”.
5. Now select “Choose a passkey for me” and click “next”.
6. Now enter generated passkey using Bluetooth keyboard and press ENTER to send code.
7. Click “finish” to end pairing process. NumLock LED on the Bluetooth keyboard should be off indicating
successful connection.
8. Now you can use your Bluetooth keyboard with touchpad. When you turn OFF and again turn ON keyboard
or PC computer connection will be established automatically.
Using the Bluetooth keyboard
To use numeric keypad you must enable it by holding “FN” key and pressing “NumLock” key. Repeat this operation
to disable it.
Loading...