Media-Tech 150M User Manual

150M WIRELESS

ROUTER

High Speed Wireless Conectivity

MT4209

Quick Guide

Overview

EN

DC input WAN port LAN port Reset switch

Conguration steps

1. Into WAN port plug via Ethernet cable Internet con­nection (other router or ADSL/DSL modem). Into
LAN port plug PC computer to congure router.

2. Make sure that network card in Your computer is set
to work with DHCP server by obtaining IP and DNS
addresses automatically. To check it, choose Proper­ties of Local area cable connection and then, choose
Properties of Internet Protocol V4 (TCP/IPv4).

2

3. Launch web browser and enter default address
http://192.168.1.1, when password message box
appears enter default name “admin” and password
“admin”.

4. Router Management screen will appear (device is set
initially to Router mode). Set password for your net­work (Key Value).

WAN interface setup

Method 1: Automatic obtain (Internet provider DHCP)

If you’re using the DHCP (auto cong) connection, the
router will receive IP parameters from your ISP. Entering
any special parameters is not neccesary.

Method 2: Fixed IP (for semi-advanced users)

When Fixed IP connection will be marked, you’ll be
asked to enter static IP data such as local IP addres,
Subnet mask, Gateway and DNS.

Method 3: PPPoE Connection

You can initiate internet connection by connected
ADSL modem to the router when the option “PPPoE
Dial-up” will be marked. Enter User name and Password
provided by your ISP.

EN

3

EN

■ To nish connection settings click “Save/Apply” but­ton.

Wireless connection to the router

For example Windows 7 OS:

■ Navigate to “Start>Control Panel>Network and
Internet>Network and Sharing Center>Change
Adapter Settings>Wireless Network Connection”.
Then right-click “Wireless network connection” and
select “Connect/disconnect”.

■ Enter Wi-Fi key and click “OK”

Note: Default SSID and Network key is printed on
the serial label on the bottom of the device.

■ Connection is succesfull.

Troubleshooting

Q: How to restore factory settings?
A: Device should be powered on. Press and hold RESET
button for 10 seconds and then release. Wait for router
reboot.
Q: My laptop cannot receive the router signal?
A: Check if the laptop’s wireless interface is turned on
and enabled. If yes, please check if all drivers
of wireless card are installed properly.
Conrm if is enabled correct function
in router (Access Point).

■ Select the wireless network name of your router
(SSID) and click “Connect”.

4

Due to continuous development specication and appearance of
product are subject to change without prior notice. For technical
support please visit www.media-tech.eu.