Me GSV-4GPRS Quick Start Manual

Quick Start GSV-4GPRS

Step 1: Insert SIMCard

• Enter SIMCard, chip facing downwards

Step 2: Preparations

In the next step you will need information about your simcard:

• PIN Number

• Internet Access Data of your GPRS Provider

• Username and Password (if required, depends on provider)

• SMS Center Number of your GPRS Provider

• Serial port number of your computer (COM1 oder COM25 … )

Step 3: Enter your PIN No

• Install the configuration jumper

• Connect Modem with computer, using a

SUB D9 connection cable

• Start Software simcard.exe

• Follow the instructions

• Remove the configuration jumper

Step 4: Test

Remove configuration jumper and serial cable.

Power on (push button for 1s)

The red LED announces a succesful connection with server.

The green LED announces network search while flashing with a frequency of 1 per
second. If green LED flashes with a frequency of 0,3 per second, it is logged in
GSM/GPRS network.

The modem needs about 60 Seconds, until it is connected with server.

ME-Meßsysteme GmbH, Neuendorfstr. 18a, DE-16761 Hennigsdorf

Tel [phone], Fax [phone], [e-mail], www.me-systeme.de 1

Software SIMCard

The software simcard.exe is a simple setup utility for your modem.

You may enter your SIMCard PIN Number, the telephone number of SMS-Service Center
and the internet-access data of your provider.

It may be used also to update the firmware of the modem.

Important note:

Befor you start the software, you should

• install the configuration jumper,

• turn off the modem.

The COM port must be opened within the first 6 seconds after the modem is switched on.

Information screen; continue with ENTER

Within 6 Seconds after power on of modem, you should enter the COM port.

Nevertheless, please wait 3 seconds after power on.

Power on: please press the button for 1 second.

ME-Meßsysteme GmbH, Neuendorfstr. 18a, DE-16761 Hennigsdorf

2 Tel [phone], Fax [phone], [e-mail], www.me-systeme.de