McAlpine CD600-O-B, CD700-O-B, CD800-O-B, CD900-O-B, CD1000-O-B Adjustment Instructions

CD600/700/800/900/1000/1200-O-B/P – Adjustment Instructions

D

C

A

D B B

A

A

D

A

D

Step 1

Screw up / Raise to the limit but without removing
the 4 screws ‘A’.

C

Step 2

Loosen to the limit but without removing the 2
screws ‘B’ and 2 screws ‘C’.

Step 3

Depending on the thickness of the le, adjust the
4 screws ‘D’ to the correct height.

Step 4

Fix the frame by ghtening the 2 screws ‘B’ and 2
screws ‘C’.

Step 5

Screw down the 4 screws ‘A’ unl you feel that
they have made contact with the drain boom.
These screws are only designed for supporng the
frame.

Attention!!
Over tightening of these screws may
cause distortion of the frame and cover.

Installation Guidelines

Slimline Channel Drain

1

2

4

3

Floor tiles

1

2

Waterproof tile adhesive

Waterproofing membrane

3

Concrete floor

4

Please Note:

McAlpine does not supply flexible

latex waterproofing/membranes for

tanking systems and advice should

be requested from the suppliers of

these products.

The following instructions refer to the installation of the channel drain only. They do not include
information regarding installation of other elements of the shower cabin, such as sealing the
connections between the shower walls and floor, or waterproofing - commonly known as room
tanking.

■

Set the level of the finished shower floor surface and mark the wall in line with the area

where the channel will be installed. Allow for the slope of the shower surface area

■

Connect the channel to the drainage system trap and waste discharge pipework and set the
height using the adjustable legs so that the upper edge of the channel frame is
approximately 1mm below the finished surface level of the shower area

■

Fill the surface under and around the channel with screed or a similar product to the level of
the flange

■

Cover the flange and surrounding area with a flexible latex waterproofing (liquid form
membrane)

■

Apply the sealing membrane in position on the freshly applied liquid

■

Apply a second coat of liquid membrane to the whole surface of the shower area and sealing
membrane

■

Once the liquid is completely dry, as per the manufacturer’s instructions, the shower surface
can then be tiled

■

Seal the gap between the tiles and the channel frame with a flexible sanitary silicone which
can be compatible with the tile grout colour

49