MBT Lighting P100BFUL User Manual

www.mbtlighting.com

INSTRUCTION MANUAL

I. Technical Specifications:

Item Code: P100BFUL / SRL-525
Name: PAR 36 PINSPOT
Volt: AC 120V
Bulb: 4515 6V/30W PAR36
Fuse: 125V/1A
Weight: 1.4kg
Size: L160xW160xH200 mm

II. Operating Instructions:

1. Unpack the carton. Check if there is any damaged or missing
parts. Call your local dealer if anything is found not in a
normal condition.

2. Open the front cover to install lamp and disconnect the unit
from power while re-lamping.

3. Use a clamp to hang the unit onto the truss, fasten tight. Tie the
unit steadily onto the truss by winding a chain through the
bracket of the unit.

4. Place the unit where there is efficient ventilation, away from
any flammable and explosive objects.

5. Check that the rated power corresponds to the main supply.

III. Re-lamping:

1. Disconnect from power supply and cool down the unit before

re-lamping.

2. Open the front cover and pull out the old lamp. Disconnect
the two wires on the rear of the old lamp and attach them to the
two screws on the new one (it does not matter which wire goes
to which screw on the lamp). Place the lamp back into place and
put the front cover back on.

• IV. Caution:

1. In order to reach a maximum of safety the following points

should be carefully read and observed.

2. Ambient temperature should not exceed 400.

3. Disconnect from the power supply before opening or

replacement of the lamp and fuse. Please be sure the lamp is cool
before replacement!

4. To avoid electrical shock, do not touch any live parts when the

unit is activated.

5. No user serviceable parts inside. Refer all service and repairs

to qualified electrical technician.

6. The lamp shall be change if it has become damaged or thermally

deformed.