MBT Lighting FAZER User Manual

FAZER FOGGER User manual

Introduction

Thank you for choosing an FAZER Fogger. You now own a rugged and powerful state-of-the-art machine. Prior to use,

we suggest that you carefully read all of the instructions .By following the suggestions found in this user manual, you can

look forward to the reliable and satisfactory performance of your FAZER Fogger for years to come.

Specification:

Model No. FAZER

Rating Voltage: 230V/50Hz

Power Consumption: 400W

Fuse: VDE 250V/3.15A

Preheating Time: 9min

Tank capacity: 1.0 Liter

Weight: 4.2kg

Measurement: L375XW168XH180MM

Please follow these operation and safety instructions to ensure a long and safe life
for your FOGGER

Cautions

 Do not overfill your FAZER Fogger. Overfilling will cause the unit to clog

Danger of electric shock

 Keep this device dry

 For inside use only. Not designed for outside use

 For the 230V models, use 3-prong grounded electrical outlet only. Prior to use take care to determine that the unit

installed at the rated voltage.

 Forbid the fogger closing up to any flame, flammable and explosive substance to avoid fire and explosive.

 Always unplug your FAZER Fogger before filling its tank.

 Keep Fogger upright

 Turn off or unplug when not in use.

 This machine is not water-or splash proof. If moisture, water, or fog liquid gets inside the housing, immediately

unplug the unit and contact a service technician or your Fogger dealer before using it again.

 No user serviceable parts inside. Refer to your Fogger dealer or other qualified service personnel.

 For adult use only. Fogger must be installed out of the reach of children. Never leave the unit running unattended.

 Never aim the output at open flames.

Danger if explosion

 Never add flammable liquids of any kind (oil, gas, perfume) to the FAZER FOGGER liquid or the fluid container.

Pay attention to all warning labels and instructions printed on the exterior of your Z-300 Fogger

 Use only high-quality liquid or suitable dealer recommended fog fluid

 Always make sure there is sufficient liquid in the Fogger liquid tank. Operating this unit without liquid may cause

permanent damage to the machine

 If your FAZER Fogger fails to work properly, discontinue use immediately. Drain all Fogger liquid from the tank,

pack the unit securely (preferably in the original packing material), and return it to your fogger dealer for service.

 Never drink Fogger liquid. If it is ingested, call a doctor immediately. If Fogger liquid comes in contact with skin

or eyes, rinse thoroughly with water.

Unpacking & Inspection

 Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact.

Your FAZER Fogger machine should be accompanied by the following items:

1. This user manual!

2. Power cord

3. ZC-6 multi-function remote control with attached cord

If any equipment is missing contact your Fogger dealer immediately.

Before beginning initial setup of your FAZER Fogger, make sure that there is no evident damage caused by

transportation. In the event that the unit’s housing or cable is damaged, do not plug it in and do not attempt to use it

until after contacting your FAZER Fogger dealer for assistance.

Setup

 Remove all packing materials from shipping box. Check that all foam and plastic padding is removed.

 Clean the spray nozzle to be sure the nozzle without any hindrance. Please contact with your vendor when you find

any destroy or omitting parts.

 Place Fogger on a flat surface and remove liquid tank cap.

 Pour high quality fog Liquid into the liquid tank, being careful not to exceed the maximum fluid level. DO NOT

OVERFILL. Use only our Fogger Liquid or other dealer-recommended high-quality Fog fluid. Any other types of

fluid can damage the unit. When the container is full ,place the cap back on the liquid tank and tighten.

 Your Fogger can only be operated by connecting the ZC-6 remote control into the remote control slot in the back of

the machine

Operation

 Plug the remote control cord into slot marked remote control on the back of the Fogger machine. Plug the power

cord into a grounded electrical outlet

 Turn on the power switch located on the back of the Fogger machine

 The red light on the remote control will turn on once the machine is plugged into a power outlet and the on/off

switch is turned on

 Once the red light comes on the machine must warm-up .This period varies depending on conditions but should not

take more than 10 minutes under any circumstances

 The green light on the remote control will turn on once the machine is ready to produce haze. When the green light

turns on, the machine may be operated using the remote control.

 The FAZER Fogger is controlled via the ZC-6 remote control. Please refer to the section titled Remote control

Operation for detailed instruction on the various functions available

 Prior to the green light turning on the machine will not haze and the functions will not respond

 When the Fogger does not have any liquid in the machine the PC board will shut off the pump so that the machine

will not be damaged. The pump will remain off until fluid is added to the machine

 Please clean the machine not more than 40 hours into the mix cleaner consist of 80% pure water and 20% vinegar

as follows.

1. Before use, dismount and clean the nozzle with vinegar to ensure it without any remains.

2. Empty the tank, then pour clean liquid instead of fog liquid to spray until clean liquid runs off.

3. Assemble the nozzle and pour the fog liquid again for next operation.

Important: