Mazi PM07-800L User Manual
Video Door Phone
Door Station and Indoor Station
User Manual
Video Door Phone·User Manual
i
User Manual
This user manual is intended for users of the video door phone.
Disclaimer
REGARDING TO THE PRODUCT WITH INTERNET ACCESS, THE USE OF PRODUCT SHALL BE WHOLLY
AT YOUR OWN RISKS. OUR COMPANY SHALL NOT TAKE ANY RESPONSIBILITES FOR ABNORMAL
OPERATION, PRIVACY LEAKAGE OR OTHER DAMAGES RESULTING FROM CYBER ATTACK, HACKER
ATTACK, VIRUS INSPECTION, OR OTHER INTERNET SECURITY RISKS; HOWEVER, OUR COMPANY
WILL PROVIDE TIMELY TECHNICAL SUPPORT IF REQUIRED.
SURVEILLANCE LAWS VARY BY JURISDICTION. PLEASE CHECK ALL RELEVANT LAWS IN YOUR
JURISDICTION BEFORE USING THIS PRODUCT IN ORDER TO ENSURE THAT YOUR USE CONFORMS
THE APPLICABLE LAW. OUR COMPANY SHALL NOT BE LIABLE IN THE EVENT THAT THIS PRODUCT IS
USED WITH ILLEGITIMATE PURPOSES.
IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE LAW, THE LATER
PREVAILS.
Support
Should you have any questions, please do not hesitate to contact your local dealer.
Video Door Phone·User Manual
ii
Regulatory Information
FCC Information
Please take attention that changes or modification not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
FCC compliance: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
EU Conformity Statement
This product and - if applicable - the supplied accessories too are
marked with "CE" and comply therefore with the applicable
harmonized European standards listed under the EMC Directive
2014/30/EU, the RoHS Directive 2011/65/EU.
2012/19/EU (WEEE directive): Products marked with this symbol cannot
be disposed of as unsorted municipal waste in the European Union. For
proper recycling, return this product to your local supplier upon the
purchase of equivalent new equipment, or dispose of it at designated
collection points. For more information see: www.recyclethis.info
2006/66/EC (battery directive): This product contains a battery that
cannot be disposed of as unsorted municipal waste in the European
Union. See the product documentation for specific battery information.
The battery is marked with this symbol, which may include lettering to
indicate cadmium (Cd), lead (Pb), or mercury (Hg). For proper recycling,
return the battery to your supplier or to a designated collection point.
For more information see: www.recyclethis.info
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (A)/NMB-3(A) standards requirements.
Video Door Phone·User Manual
iii
Symbol Conventions
The symbols that may be found in this document are defined as follows.
Symbol
Description
NOTE
Provides additional information to emphasize or
supplement important points of the main text.
CAUTION
Indicates a potentially hazardous situation, which
if not avoided, could result in equipment damage,
data loss, performance degradation, or
unexpected results.
DANGER
Indicates a hazard with a high level of risk, which
if not avoided, will result in death or serious
injury.
Safety Instruction
All the electronic operation should be strictly compliance with the electrical safety
regulations, fire prevention regulations and other related regulations in your local
region.
Please use the power adapter, which is provided by normal company. The power
consumption cannot be less than the required value.
Do not connect several devices to one power adapter as adapter overload may cause
over-heat or fire hazard.
Please make sure that the power has been disconnected before you wire, install or
dismantle the device.
When the product is installed on wall or ceiling, the device shall be firmly fixed.
If smoke, odors or noise rise from the device, turn off the power at once and unplug
the power cable, and then please contact the service center.
If the product does not work properly, please contact your dealer or the nearest
service center. Never attempt to disassemble the device yourself. (We shall not
assume any responsibility for problems caused by unauthorized repair or
maintenance.)
Do not drop the device or subject it to physical shock, and do not expose it to high
electromagnetism radiation. Avoid the equipment installation on vibrations surface or
places subject to shock (ignorance can cause equipment damage).
Do not place the device in extremely hot (refer to the specification of the device for
the detailed operating temperature), cold, dusty or damp locations, and do not
expose it to high electromagnetic radiation.
The device cover for indoor use shall be kept from rain and moisture.
Exposing the equipment to direct sun light, low ventilation or heat source such as
heater or radiator is forbidden (ignorance can cause fire danger).
Do not aim the device at the sun or extra bright places. A blooming or smear may
occur otherwise (which is not a malfunction however), and affecting the endurance of
sensor at the same time.
Video Door Phone·User Manual
iv
Preventive and Cautionary Tips
Please use the provided glove when open up the device cover, avoid direct contact
with the device cover, because the acidic sweat of the fingers may erode the surface
coating of the device cover.
Please use a soft and dry cloth when clean inside and outside surfaces of the device
cover, do not use alkaline detergents.
Please keep all wrappers after unpack them for future use. In case of any failure
occurred, you need to return the device to the factory with the original wrapper.
Transportation without the original wrapper may result in damage on the device and
lead to additional costs.
Do not expose the device to the explosive situation.
Do not expose the device to the corrosive gas. Otherwise the equipment damage may
occur.
Please wire the power cable according to the instruction as wrong wiring may cause
equipment damage.
Do not allow the child to push the device from the bottom just in case the device
drops and hits the child.
Do not splash the water on the device. Device short circuit or other damages may
occur if the water enters into the device.
Do not expose the device to the sun bright for a long time, otherwise the screen of
the device may fall off.
Please watch out for the glass fragments if the device drops. Avoid scratched or
damaged by the glass fragments and do not allow the child to touch the glass
fragments.
It is suggested that you should smear the glass glue around the device after
installation.
Please make sure no child stands under the device when installing the device. The
device may hit the child in case the device drops in the installation process.
Do not expose the device to high electromagnetism radiation.
Video Door Phone·User Manual
v
Table of Contents
1 Introduction ................................................................................................. 1
1.1 Overview .................................................................................................................. 1
1.2 Features ................................................................................................................... 1
2 Appearance Description ............................................................................... 2
2.1 Indoor Station .......................................................................................................... 2
2.2 Door Station............................................................................................................. 2
3 Terminals and Wirings .................................................................................. 3
3.1 Terminals and Interfaces .......................................................................................... 3
3.1.1 Terminals of Indoor Station ............................................................................... 3
3.1.2 Terminals of Door Station .................................................................................. 3
3.2 Wiring Description ................................................................................................... 4
3.2.1 Wiring 1 (1 Door Station and 1 Indoor Station)................................................. 6
3.2.2 Wiring 2 (1 Door Station and 3 Indoor Stations) ............................................... 7
3.2.3 Wiring 3 (2 Door Stations and 3 Indoor Stations) ............................................. 8
4 Installation ................................................................................................... 9
4.1 Indoor Station Installation ....................................................................................... 9
4.2 Door Station Installation ........................................................................................ 10
5 Local Operation .......................................................................................... 12
5.1 Door Station Local Operation ................................................................................ 12
5.2 Indoor Station Local Operation .............................................................................. 12
Appendix ...................................................................................................... 13
Installation Notice ....................................................................................................... 13
Loading...