Maytag TDL-0050B-B User Manual

Technical Bulletin

a

Type Policy Letter
√ Service Information

Attention Service Managers
√ Service and Parts Managers

Models AAV1200AGW, AAV1200AJW, AAV1200AKW, AAV1200ARW,
AAV1200AWW, AAV2200AGW, AAV2200AJW, AAV4200AGW,
ALW221RJW ,CAV1000AWW, CAV2000AGW, CAV2000AJW,

CAV2000AKW, CAV2000AWQ, CAV2000AWW, CAV4000AWW,
CW5000W, CW6000Q, CW6000W, CW7500Q, CW7500W, DLW231RAW,
HAV1200ARW, HAV1200AWQ, HAV1200AWW, HAV2360AWW,
HAV2460AWW, HAV2557AWW, HAV2558AWW , HAV3460AWW,
HAV4200AKW, HAV4200ATW, HAV4200AWW, HAV4657AWW,
JAV4200AWQ, LNC6760B71, LNC6762B01, LNC6762B71, LNC6764A71,
LNC6766B71, MAV2200AJW, NAV3200AW W, NAV4200AGW,
NAV4200AKW, PAV1200AWW, PAV2200AAW, PAV2200AGW,

PAV2300AGW, PAV2300AW W,PAV2360AWW, PAV3200AAW,

PAV3200AGW, PAV3240AW W, PAV3300AGW,PAV3300AKW,
PAV3300AWW, PAV3360AWW, PAV4960AWW , PAV5000AWQ,
PAV5000AWW, PAV5057AWW, PAV5058AWW , PAV5157AWW,
PAV5158AWW, PAVT234AW W, PAVT244AWW, PAVT344AWW,

PAVT444AWW

Issue Wash basket leans to one side, generally to the right as you face the washer
during spin cycle.

Warranty Standard product manufacturing warranty applies.

Action Replace original base with Kit 12002701. The replacement of the base, new snubber,

and six springs (included in the Kit) will reduce tub lean to an acceptable level.

NOTE: Some tub lean is normal.

1. Disconnect power supply to unit.

2. Tilt washer and remove belt from underside of base.

3. Remove back cover to access and remove drain hose clamps.

NOTE: There will be water remaining in the hose from the last cycle.

Date: September 2005

No: TDL-0050B-B

ITDL-0020A-B
Page 1 of 4
Supersedes TDL-0050A-B
ITDL-0020-B

Brand

Admiral
Amana
Crosley
Jenn-Air
Magic Chef
Maytag
Maytag Perform

Product

Laundry

© 2005 Maytag Services

4. Remove three screws attaching drain pump to base.

5. Lift top cover by inserting a plastic putty knife between top cover and front panel. Press the locking clip to
release the top cover. Repeat for both sides. Remove front panel by removing screws, one on each side of
the top edge of front panel.

6. Remove motor ground wire, motor shield, and motor wire harness connector.

Page 2 of 4 © 2005 Maytag Services TDL-0050B-B
9/30/2005 ITDL-0020A-B