Maytag MVWC300V, MVWC500V, MVWC700V Dimension Guide

39"

(99 c m )

28"

(71 c m )

PRODUCT MODEL NUMBERS

DRAIN SYSTEM OPTIONS

MVWC300V
MVWC500V
MVWC700V

Electrical: A 120-volt, 60-Hz, AC-only,
15- or 20-amp, fused electrical supply is required.
A time-delay fuse or circuit breaker is
recommended. It is recommended that a separate
circuit serving only this appliance be provided.
Do not use an extension cord.

Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.

Ref. W10200331B

10-28-08

RECESSED AREA OR CLOSET INSTALLATION

If a closet door is installed, the minimum ventilation openings in the top and bottom of
the door are required (view 3). Louvered doors with equivalent air ventilation openings in
the top and bottom are acceptable.

Laundry tub drain system (view 3)

The laundry tub needs a minimum
20 gal. (76 L) capacity. The top of
the laundry tub must be at least
39" (99 cm) above the floor and
no higher than 96" (244 cm) from
the bottom of the washer.

Floor drain system (view 4)

The floor drain system requires a siphon
break that may be purchased separately.

The siphon break must be a minimum
of 28" (71 cm) from the bottom of the
washer. Additional hoses might be
needed.

"

"

"

"

"

"

"

"

"

"

"

"

12 3

39"

(99 c m )

Front view Side view Closet door with vents

12

34

Standpipe drain system - wall or floor (view 1 & 2)

The standpipe drain requires a minimum diameter standpipe of
2" (5 cm). The minimum carry-away capacity can be no less
than 17 gal. (64 L) per minute.

The top of the standpipe must be at least 39" (99 cm) high and
no higher than 96" (244 cm) from the bottom of the washer.

IMPORTANT: To avoid siphoning, no more than 8" (20.3 cm) of
drain hose should be inside the standpipe.

Washer