Maytag MQF1656TEW, MQF2056TEW Dimension Guide

including
handle
C
B
A
Freezer
PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS
LOCATION REQUIREMENTS
MQF1656TE MQF2056TE
Recommended grounding method
Water Pressure
A cold water supply with water pressure of between 30 and 120 psi (207 to 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about your water pressure, see “Troubleshooting” or call a licensed, qualified plumber.
Reverse Osmosis Water Supply
If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the system needs to be a minimum of 40 to 60 psi (276 to 414 kPa).
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.
Ref. W10326798C
3/14/14
IMPORTANT: Do not install the freezer near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 40°F (5°C).
Check the strength of the floor before installing your freezer. It should hold the weight of a freezer fully loaded with food.
Allow at least 3" (7.5 cm) of air space at the top and on both sides of the freezer and 1" (2.5 cm) between the back of the freezer and the wall. If the freezer is to be against a wall, leave extra space on the hinge side so the door can open wider.
NOTE: This freezer may be installed side by side with another refrigerator or freezer. Allow for a 3" (7.5 cm) clearance at the top and sides and a
1
4" (0.64 cm) clearance between the appliances.
Model
Number Model Size Height “A” Width “B” Depth “C”
MQF1656TE 15.8 cu. ft.
61⁵⁄₁₆"
(155.7 cm)
30 " (76.2 cm)
31⁵⁄₁₆" (79.5 cm)
MQF2056TE 20.1 cu. ft.
67⁵⁄₁₆"
(171.0 cm)
33" (83.8 cm)
31⁵⁄₁₆" (79.5 cm)
3" (7.5 cm)
3" (7.5 cm)
Loading...