Maytag MMW5527BAW Installation

INSTALLATION

INSTRUCTIONS

Built-In 27" & 30"

Electric Wall Ovens

403 WEST FOURTH STREET, NORTH · NEWTON IA 50208

27" SINGLE WALL OVEN

1 1/4" Dia Conduit Access Hole*

1
2 5/8" Plywood Floor (Must Support 142 lbs)

DIMENSIONS

in cm

A

27MIN 68.58

B

24 MIN 60.96

C

27 7/16

D
E
F
G

H

I

1

2

A
B
C
D
E
F
G

H

I

±1/16 69.69

23 1/2 MIN 59.69

±1/16 64.77

25 1/2

27 3/4 70.49

26 3/4 67.95

24 7/16 62.07

4 to 33 10.2 to 83.8

27" DOUBLE WALL OVEN

1 1/4" Dia Conduit Access Hole*

5/8" Plywood Floor (Must Support 250 lbs)

DIMENSIONS

in cm

27 MIN 68.58

24 MIN 60.96

49 5/8

±1/16 126.05

23 1/2 MIN 59.69

25 1/2

±1/16 64.77

49 15/16 126.84

26 3/4 67.95

24 7/16 62.07

4 to 12 10.2 to 30.5

30" SINGLE WALL OVEN

1 1 1/4" Dia Conduit Access Hole*
2

5/8" Plywood Floor (Must Support 142 lbs)

DIMENSIONS

A
B
C

D
E
F
G

H

I

1
2

A
B
C

D
E
F

G
H

I

in cm
30 MIN 76.20
24 MIN 60.96

±1/16 69.69

27 7/16

23 1/2 MIN 59.69

±1/16 71.60

28 3/16

27 3/4 70.49

29 3/4 75.57

24 7/16 62.07

4 to 33 10.2 to 83.8

30" DOUBLE WALL OVEN

1 1/4" Dia Conduit Access Hole*

5/8" Plywood Floor (Must Support 250 lbs)

DIMENSIONS

in cm
30 MIN 76.20
24 MIN 60.96

49 5/8

±1/16 126.05

23 1/2 MIN 59.69

±1/16 71.60

28 3/16

49 15/16 126.84

29 3/4 75.57

24 7/16 62.07

4 to 12 10.2 to 30.5

SINGLE WALL OVEN

DOUBLE WALL OVEN

30" WALL OVEN UNDER COUNTER27" WALL OVEN UNDER COUNTER

1

1 1/4" Dia Conduit Access Hole*

2

5/8" Plywood Floor (Must Support 142 lbs)

DIMENSIONS

in cm
A
B
C
D

E
F
G

H

I

J

25 63.50

24 MIN 60.96

27 7/16 ±1/16 69.69

23 1/2 MIN 59.69

25 1/2 ±1/16 64.77

27 3/4 70.49

26 3/4 67.95

24 7/16 62.07

36 91.44

1 1/2 3.81

27" WALL OVEN 30" WALL OVEN

* * COOKTOPS

K 4 Burner Gas 2 1/8 MIN 5.4 MIN 2 1/8 MIN 5.4 MIN
K Electric 3 1/8 MIN 7.9 MIN 3 1/8 MIN 7.9 MIN
K Induction 3 1/8 MIN 7.9 MIN 3 1/8 MIN 7.9 MIN

in cm in cm

1

1 1/4" Dia Conduit Access Hole*

2

5/8" Plywood Floor (Must Support 142 lbs)

DIMENSIONS

in cm
A
B
C
D

E
F
G

H

I

J

25 63.50

24 MIN 60.96

27 7/16 ±1/16 69.69

23 1/2 MIN 59.69

28 3/16 71.60

27 3/4 70.49

29 3/4 75.57

24 7/16 62.07

36 91.44

1 1/2 3.81

NOTE: * Hole must be cut as close to corner of cabinet as possible.

** See Dealer for approved cooktops.

NOTES

Z Do not block air intake slots along bottom of oven
Y Gas or electric cooktops may be installed over ovens. See

cooktop installation instructions for cutout size.

W Electrical connection for electric cooktop must be in adjacent ac

cessible location. Cooktop and wall oven must be on separate
120/240 or 120\208 volt 60 Hz AC circuits.

8101P306-60

(04-99-01)

-

When installing a 27" walloven under a 30" cooktop some
interference may occur. The following cutout notching of
the side trims will eliminate the interference of the side trim
to the burner box. After cutting, file the side trim edges to
eliminate burrs.

Installing Bottom Trim Piece

Electrical Connections

Unit to be properly circuit protected and wired according to
local electrical code and National Electrical Code.

It is advisable that the electrical wiring and hookup be
accomplished by a competent electrician.

CAUTION

For European style cabinets (flush front) the required
clearance for operation of the oven door is minimum
spacing of 7/8" between the cutout and the door,
hinge or drawer of the cabinet.

Some built-in cabinets may not be wide enough,
due to their construction, to allow this installation.

1. Cut hole in cabinet to mount oven. Cutout in cabinet

should be level and straight.
Note: There are no provisions to level the unit after it

is installed. An oven that is not level could
cause poor baking results.

2. Install plywood floor as shown.

3. Attach unit to the cabinet with four No. 8x1" screws

supplied with unit inside of envelope containing these
instructions. Pre-drill holes in cabinet for attachment
screws using 1/8" drill. Oven mounting holes are
provided in side trim.

120/240 VAC or 120/208 VAC 60 Hz. See serial plate on
front of unit for power requirements.

The neutral of this unit is grounded to the frame through the
green or solid grounding wire. (The green and the white
wires are twisted together at the termination of the conduit.)
If local conditions do not permit grounding of the neutral,
untwist the green wire and connect the green wire to
ground in accordance with local codes. Connect the white
neutral to the service neutral.

The chart below recommends the minimum circuit
protection and wire size if the appliance is the only unit on
the circuit.

RECOMMENDED MINIMUM

K.W. RATING CIRCUIT PROTECTION WIRE SIZE

ON SERIAL PLATE IN AMPERS (AWG)

15,0 -14.8 20 12

14.9 -16.9 30 10

17.0 -19.9 40 18

10.0 - 11.9 50 18

12.0 - 14.9 60 16

Service

4. See instructions at right for electrical hook-up.

5. See Use and Care Manual for operating instructions.

IMPORTANT - SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE

Interrupt the source of electricity to the unit when attempting
to repair or service the oven. Failure to do this could result
in a dangerous or even fatal shock.

8101P306-60

(04-99-01)