Replace plastic or foil vent material with 4” (102 mm)
diameter heavy, rigid vent material.
n
Use the shortest length of vent possible.
n
Use no more than four 90° elbows in a vent system;
each bend and curve reduces air ow.
Good Better
Good air ow
Along with heat, dryers require good air ow to efciently
dry laundry. Proper venting will reduce your drying times and
improve your energy savings. See Installation Instructions.
The venting system attached to the dryer plays a big role in
good air ow.
Service calls caused by improper venting are not covered by
the warranty and will be paid by the customer, regardless of
who installed the dryer.
n
Remove lint and debris from the exhaust hood.
n
Remove lint from the entire length of the vent system at
least every 2 years. When cleaning is complete, be sure to
follow the Installation Instructions supplied with your dryer
for nal product check.
n
Clear away items from the front the dryer.
Use Auto Ciclos (Auto Cycles) for better fabric care and energy savings
Use the Auto Ciclos (Auto Cycles) to provide the most energy savings and enhanced fabric care from the dryer. During Auto Ciclos
(Auto Cycles), drying air temperature and moisture level are sensed in the load. This sensing occurs throughout the drying cycle and
the dryer shuts off when the load reaches the selected dryness.
With Ciclos Manuales, the dryer runs the amount of time set and sometimes results in shrinkage, wrinkling, and static due to
over-drying. Use Ciclos Manuales (Timed Cycles) for the occasional damp load that needs a little more drying time or when using
the drying rack.
4
CONTROL PANEL & FEATURES
231
7
Not all features and options are available on all models.
BOTÓN DE ENCENDIDO/APAGADO/CANCELAR
1
(Power/Off/Cancel Button)
Press to turn the dryer on and off, or to cancel a cycle.
DRYER CYCLE KNOB
2
Use your dryer cycleknob to select available cycles on your
dryer. Turn the knob to select a cycle for your laundry load.
See “Cycle Guide” for detailed descriptions of cycles.
BOTÓN DE INICIO/PAUSA (Start/Pause Button)
3
Press to start a cycle, or press once while a cycle is in
process to pause it.
4
AJUSTE DE CICLO (Cycle Modiers)
Temperatura (Temperature)
Select a drying temperature based on the fabrics in your load.
If you are unsure of the temperature to select for a load, select
the lower setting rather than the higher setting.
NOTE: The Sólo aire (Air Dry) feature is not available on
the Auto Ciclos (Auto Cycles).
Protección anti arrugas (Wrinkle Prevent)
When you are unable to remove a load of clothes from the
dryer as soon as it stops, wrinkles can form. The Protección
anti arrugas (Wrinkle Prevent) feature periodically tumbles,
rearranges, and uffs the load to help keep wrinkles
from forming.
n
Get up to 60 or 150minutes for models with two
choices, 90 minutes for models with only one choice
of heat-free, periodic tumbling at the end of a cycle.
Press the PROTECCIÓN ANTI ARRUGAS (Wrinkle
Prevent) button at any time before the cycle has ended,
“Si” (Yes) will light up.
6
Appearance may vary.
5
SIGNALS
Alarma (Signal)
The Alarma (Signal) produces an audible sound when the
drying cycle is nished. Promptly removing clothes at the
end of the cycle reduces wrinkling.
Press ALARMA (Signal) to select, “Si” (Yes) will light up.
NOTE: When the Protección anti arrugas (Wrinkle Prevent)
setting is selected and the Alarma (Signal) is on, the tone will
sound every 20minutes until the clothes are removed, or the
Protección anti arrugas (Wrinkle Prevent) setting ends.
CYCLE STATUS LIGHTS
6
Lights indicate the progress of the drying cycles.
7
INTELLIDRY™
Senses moisture in the load or air temperature and shuts off
when the load reaches the selected dryness level. Gives the
best drying in the shortest time. Drying varies based on fabric
type, load size, and dryness setting.
4
5
5
CYCLE GUIDE — AUTO CICLOS (AUTO CYCLES)
Not all cycles and settings are available on all models. Settings and options shown in bold are default settings for that cycle.
AUTO CICLOS (Auto Cycle) - Senses moisture in the load or air temperature and shuts off when the load reaches the selected dryness
level. Gives the best drying in the shortest time. Drying time varies based on fabric type, load size, and dryness setting.
Depending on model, temperature may be selected on cycle knob or be a separate control.
Items to dry:
Cycle:
Default
Available Options:
Cycle Details:
Time:
Jeans, heavy work
clothes, towels
Work clothes,
medium weight
fabrics, sheets
Casual, shirts,
pants, lightweight
items
Pesado
(Heavy)
Normal
Control de arrugas
(Wrinkle Control)
N/A
N/A
N/A
Temperatura (Temperature)
Protección anti arrugas (Wrinkle Prevent)
Temperatura (Temperature)
Protección anti arrugas (Wrinkle Prevent)
Temperatura (Temperature)
Protección anti arrugas (Wrinkle Prevent)
Gives the best drying in the shortest time.
Drying time varies based on fabric type,
load size, and dryness setting.
Select a drying temperature based on the
fabrics in your load. If you are unsure of
the temperature to select for a load, select
the lower setting rather than the higher
setting.
CYCLE GUIDE — CICLOS MANUALES (TIMED CYCLES)
Not all cycles and settings are available on all models. Settings and options shown in bold are default settings for that cycle.
CICLO MANUAL (Timed Cycle) - Will run the dryer for the specied time on the control. Depending on model, temperature may
be selected on cycle knob or be a separate control.
Items to dry:Cycle:
Any load
Rubber, plastic, heat
sensitive fabrics
Ciclos
manuales
(Timed cycles)
Ciclos
manuales
(Timed cycles)
Drying
Temperature:
Any
Sólo aire
(Air only)
Available
Options:
Temperatura
(Temperature)
Protección anti arrugas
(Wrinkle Prevent)
Temperatura
(Temperature)
Protección anti arrugas
(Wrinkle Prevent)
Dries items to a damp level for items that do not
require an entire drying cycle.
Select a drying temperature based on the fabrics in
your load. If you are unsure of the temperature to
select for a load, select the lower setting rather than
the higher setting.
Use a Sólo aire (Air only) setting for foam, rubber,
plastic, or heat-sensitive fabrics.
Cycle Details:
Setting the Drying Temperature
If your dryer has multiple heat settings:
An Alta (High) heat setting may be used for drying heavyweight
items such as towels and work clothes.
A (Baja) Low to Media (Medium) heat setting may be used for
drying medium-weight items such as sheets, blouses, dresses,
underwear, permanent press fabrics, and some knits.
6
Use a Sólo aire (Air only) setting for foam, rubber, plastic,
or heat-sensitive fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures
for various loads, refer to the care label directions.
USING YOUR DRYER
1.Clean the lint screen
Clean the lint screen before each load. Pull the lint screen straight
up. Roll lint off the screen with your ngers. Do not rinse or wash
screen to remove lint. Push the lint screen rmly back into place.
For additional cleaning information, see “Dryer Care”.
2.Load the dryer
3.Press ENCENDIDO (Power)
Press the ENCENDIDO (Power) button to turn on the dryer.
4.Select the desired cycle
Place laundry in the dryer. Close the door. Do not overload the
dryer; clothes should be able to tumble freely.
Select the desired cycle for your load. See the “Cycle Guide”
or the display for more information about each cycle.
7
5.Setting modiers
The default cycle settings will be shown. For some cycles, you
may select alternate settings by pressing the button for that
setting. Time adjusts for Ciclos Manuales (Manual Cycles) only.
NOTE: Not all modiers are available with all cycles.
6.Press INICIO/PAUSA (Start/Pause)
to begin cycle
DRYER CARE
Cleaning the dryer location
Keep dryer area clear and free from items that would block the
air ow for proper dryer operation. This includes clearing piles
of laundry in front of the dryer.
Press the INICIO/PAUSA (Start/Pause) button to begin the cycle.
7.Remove garments promptly
after cycle is nished
Promptly remove garments after cycle has completed to reduce
wrinkling. Use the Protección anti arrugas (Wrinkle Prevent)
feature to avoid wrinkling when you are unable to remove a load
from the dryer as soon as it stops.
Cleaning the dryer interior
To clean dryer drum
1. Apply a liquid, nonammable household cleaner to the
stained area of the drum and rub with a soft cloth until
stain is removed.
2. Wipe drum thoroughly with a damp cloth.
3. Tumble a load of clean cloths or towels to dry the drum.
NOTE: Garments that contain loose dyes, such as denim blue
jeans or brightly colored cotton items, may discolor the dryer
interior. These stains are not harmful to your dryer and will
not stain future loads of clothes. Dry these items inside out
to avoid drum staining.
Removing accumulated lint
From Inside the Dryer Cabinet
Lint should be removed every 2 years, or more often, depending
on dryer usage. Cleaning should be done by a qualied servicer.
From the Exhaust Vent
Lint should be removed every 2 years, or more often, depending
on dryer usage.
8
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.