Maytag MFI2266AEU, MFI2266AES, MFI2266AEQ, MFI2266AEW Dimension Guide

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS
LOCATION REQUIREMENTS
MFI2266AE
Electrical: A 115 Volt, 60 Hz., AC only 15- or 20­amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer Control, depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer Control, depending on the model) to the desired setting.
Water: A cold water supply with water pressure between 35 and 120 psi (241 and 827 kPa) is required to operate the water dispenser and ice maker.
If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the system needs to be a minimum of approximately 40 to 60 psi (276 to 414 kPa).
IMPORTANT: The pressure of the water coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa).
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.
Ref. 12828181B
08-15-08
4
1
D
overall
C
top of
cabinet
B
not incl.
handle
incl.
handle
A
E
Model # Depth Cab. Width Cab. Height Overall Height Depth
"A" "B" "C" "D" "E"
MFI2266AE 31-7/8" 32-5/8" 68-5/8" 70-1/8" 34-1/4"
(80.98 cm) (82.88 cm) (174.31 cm) (177.12 cm) (87 cm)
To ensure proper ventilation for your refrigerator, allow for 1⁄2" (1.25 cm) space at the top and behind the refrigerator. When installing your refrigerator next to a fixed wall, leave 3-3/4" (9.5 cm) minimum on both sides to allow for the doors to swing open. If your refrigerator has an ice maker, allow extra space at the back for the water line connections.
NOTE: Do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will either fall below 55°F (13°C) or rise above 110°F (43°C).
French Door Refrigerator
3-3/4" (9.5 cm)
1/2"
(1.25 cm)
Loading...