Maytag MDB8969SDM3, MDB8969SDM2, MDB8969SDH3, MDB8969SDH2, MDB8969SDE3 Owner’s Manual
...
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
This is the safety alert symbol.
These words mean:
You can be killed or seriously injured if you don't immediately follow instructions.
You can be killed or seriously injured if you don't follow instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the
instructions are not followed.
iMPORTANT SAFETY iNSTRUCTiONS
WARNING: When using the dishwasher, follow basic precautions, including the following:
[] Read all instructions before using the dishwasher. [] Do not tamper with controls.
[] Use the dishwasher only for its intended function.
[] Use only detergents or rinse agents recommended for use in a
dishwasher, and keep them out of the reach of children.
[] When loading items to be washed:
1) Locate sharp items so that they are not likely to damage the
door seal; and
2) Load sharp knives with the handles up to reduce the risk of
cut-type injuries.
[] Do not wash plastic items unless they are marked
"dishwasher safe" or the equivalent. For plastic items not so
marked, check the manufacturer's recommendations.
[] Do not touch the heating element during or immediately after
use.
[] Do not operate the dishwasher unless all enclosure panels are
properly in place.
SAVE THESE iNSTRUCTiONS
[] Do not abuse, sit on, or stand on the door, lid, or dish racks of
the dishwasher.
[] To reduce the risk of injury, do not allow children to play in or
on the dishwasher.
[] Under certain conditions, hydrogen gas may be produced in a
hot water system that has not been used for two weeks or
more. HYDROGEN GAS IS EXPLOSIVE. If the hot water system
has not been used for such a period, before using the
dishwasher turn on all hot water faucets and let the water flow
from each for several minutes. This will release any
accumulated hydrogen gas. As the gas is flammable, do not
smoke or use an open flame during this time.
[] Remove the door or lid to the washing compartment
when removing an old dishwasher from service or
discarding it.
State of California Proposition 65 Warnings:
WARNING: This product contains one or more chemicals known to the State of California to cause cancer.
WARNING: This product contains one or more chemicals known to the State of California to cause birth defects or other reproductive harm.
W10599529A
Donot use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
GROUNDING iNSTRUCTiONS
[]
For a grounded, cord-connected dishwasher:
The dishwasher must be grounded. In the event of a
malfunction or breakdown, grounding will reduce the risk of
electric shock by providing a path of least resistance for
electric current. The dishwasher is equipped with a cord
having an equipment-grounding conductor and a grounding
plug. The plug must be plugged into an appropriate outlet
that is installed and grounded in accordance with all local
codes and ordinances.
WARNING: Improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
SAVE THESE iNSTRUCTiONS
TipOverHazard
Check with a qualified electrician or service representative if
you are in doubt whether the dishwasher is properly
grounded. Do not modify the plug provided with the
dishwasher; if it will not fit the outlet, have a proper outlet
installed by a qualified electrician.
For a permanently connected dishwasher:
The dishwasher must be connected to a grounded metal,
permanent wiring system, or an equipment-grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or lead on
the dishwasher.
AdjustableUpperRack(o.somemodels)
You can raise or lower the top rack to
fit tall items in either the upper or
lower rack.
To Raise: Press both rack adjusters
and lift rack until it is in the up position
and level.
To Lower: Press both rack adjusters
and push rack down into its lower position.
FollowtheprogressofyourDishwasher
Depending on your model, progress will be displayed by a full lit display
or by an indicator light on the front panel.
The full lit display will glow for
wash(A), dry(B), lock(C), sanitized, or
clean. Itwill also show the estimated
remaining time for the cycle in hours and
minutes.
When delay is selected, the full lit display
will show an "h" for hour and the number of
hours to delay.
The indicator light will glow blue for wash,
red for dry, or green for cycle complete.
0
Drying- RinseAidisessential
Rinse aid along with Heated Dry and
Sanitize options will provide best
drying and avoid excessive moisture
in dishwasher interior.
BETTERDRY_G Fu_=
Md
t USERINSEAIDFO_
Energyefficiency
Auto senses load size, soil amount, and toughness of soil.
This cycle is optimized to achieve the best cleaning with
using minimal water and energy consumption. Efficient
dishwashers run longer to save water and energy, just as
driving a car slower saves on gas. Your first cycle will run
longer to calibrate the optical sensor.
When you need fast results, Quick Wash will clean your
dishes but use slightly more water and energy.
auto
©
PressSTART/RESUiViEeverytimeyouadda dish.
IMPORTANT: If anyone opens the door (such as, to ©
add a dish, even during the Delay option), the Start/
Resume button must be pressed each time.
If Start/Resume button is located on top of door: Push ......
door firmly closed within 4 seconds of pressing START/
RESUME. If door is not closed within 4 seconds, the start button LED
will flash, an audible tone will be heard (on top control models), and
cycle will not start.
Recommendeddetergent
The United States and Canada have jJ
passed a restriction limiting the
amount of phosphorus (phosphates)
in the household dishwasher
detergents to no more than 0.5%,
where previous detergents contained
8.7%. Major manufacturers have
reformulated their dishwasher
detergents for this change in
detergents as another step in eco-conscious awareness. With these
recent changes it is recommended to use tablets and packs for
convenience and improved performance.
start
heated dry
0
@
1[, PrepareandLoadDishwasher 3, AddDetergent
NOTE: If you do not plan to run a wash cycle soon, run a rinse cycle.
Do not use detergent.
• Use automatic dishwasher detergent only. Add powder, liquid or
tablet detergent just before starting a cycle.
• Fresh automatic dishwasher J
detergent results in better
cleaning. Store tightly closed
detergent container in a cool, dry
place. \
PremeasuredDetergents
Upper rack Lower rack
IMPORTANT: Remove leftover food, bones, toothpicks and other hard
items from dishes. Remove labels from containers before washing.
• Make sure when dishwasher door is closed no items are blocking
detergent dispenser.
• Angle dirtiest dish surfaces downward allowing space for water to
flow up through rack and between dishes.
Avoid overlapping items like bowls or plates that may trap food.
Place plastics, small plates and glasses in upper rack.
Wash only items marked "dishwasher safe."
To avoid thumping/clattering noises during operation: Load dishes
so they do not touch one another. Make sure lightweight items are
secured in racks.
Additional loading patterns are available online at
www.maytag.co m/manuals.
When loading silverware, always place sharp items pointing down
and avoid "nesting" as shown. If your silverware does not fit into
designated slots, flip covers up and mix silverware types to keep
them separated.
• Use slots in the covers and suggested loading patterns to keep
your silverware separated for optimum wash.
................................ /
2, CheckThatA((ArmsSpinFreely
Many detergents now come in
premeasured forms (gel packs,
tablets, or powder packs). These forms are suitable for all hardness and
soil levels.Always place premeasured detergents in main compartment
and close lid.
Using dishwasher detergent tablets and packs has proven better than
powder, liquid or gel detergents at reducing filming onyour dishes.
Using tablets and packs over time, will start to reduce or eliminate white
film. Also, by using a rinse aid you can minimize repeat buildup of white
film.
NOTE: Follow instructions on the package when using other
dishwasher detergent types.
4, AddRinseAid
Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid your dishes and dishwasher interior
will have excessive moisture. The heat dry option will not perform
as well without rinse aid.
Rinse aid keeps water from forming droplets that can dry
as spots or streaks. It also improves drying by allowing
water to drain off of dishes after final rinse.
To add rinse aid, turn
dispenser cap and lift off.
Pour rinse aid into opening
until indicator level is at
"Full." Replace dispenser
cap and turn to "Lock."
Make sure cap is fully
locked.
NOTE: For most water conditions, the factory setting will give good
results.
Check water hardness level to ensure there are no rings or spots on
dishware before adding rinse aid or adjusting the factory setting.
If you are experiencing poor drying performance, you may want to
try a higher setting.
Turn the arrow adjuster inside the dispenser to change
rinse aid setting.
i
USERINSEAID FOR
BETTERDRYING
Full
Add
Add
,5 = SeJect a CycJe(cyclesvarybymodel)
7, Start or Resumea CycJe
Efficient dishwashers run longer to save water and energy, just as
driving a car slower saves on gas. Estimated cycle time will be
displayed. Cycle times may increase or decrease depending on
selections. Estimated cycles times after calibraton are listed below.
NOTE: Run hot water at sink nearest your dishwasher until water is hot.
Turn off water.
• If Start/Resume button is located on top of door, push door firmly
closed within 4 seconds of pressing START/RESUME. If door is not
closed within 4 seconds, the Start button LED will flash, an audible
tone will be heard (on top control models), and cycle will not start.
6 =SeJectOptions(optionsvarybymodel)
You can customize your cycles by pressing the options desired. If you
change your mind, press the option again to turn off the option. Not all
options are available for every cycle. Ifan invalid option is selected for a
given cycle, lights will flash.
IMPORTANT: If anyone opens the door (such as, adding a dish, even
during the Delay Hours option), Start/Resume button must be pressed
each time.
If Start/Resume button is located on front of door, push door firmly
closed. The door latches automatically. Select the wash cycle,
options and press START/RESUME or press START/RESUME to
repeat the same cycle and options as in previous wash cycle.
This information covers several different models. Your dishwasher may not have all cycles and options described.
Targets toughest food soils. Use for hard-to-clean heavily soiled pots, pans, casseroles, and tableware.
PowerBlast TM
(D
3:28 9.0 (34.0)
normal
©
rinse
©
This cycle with only the Heated Dry option selected, and without other options selected, is
recommended to completely wash and dry a full load of normally soiled dishes. The energy usage label
is based on this cycle and option combination.
Use for rinsing dishes, glasses, and silverware that will not be washed right away.
Do not use detergent. During cycle, the rinse action will repeatedly pause for several seconds.
Cycle times may increase depending on water temperature, heavy soil condition, dish load size and options selected.
*Adding options will add time to cycle. See options information.
©
detay
Runs dishwasher at a later time or during off-peak electrical
hours. Select a wash cycle and options. Press Delay one
time for each additional hour of delay up to 24 hours. Press
START/RESUME. Close door firmly.
Available Delays start of a
with any cycle up to
cycle 24 hours.
NOTE: Anytime door is opened (such as, to add a dish),
START/RESUME button must be pressed again to resume
delay countdown.
1:51 3.8 (14.5)
:11 1.3 (4.9)
NA NA
sanitize
©
contro| lock
hold 3 sec
Sanitizes dishes and glassware by raising water
temperature in final rinse. In accordance with NSF/ANSI
Standard 184 for Residential Dishwashers. Certified
residential dishwashers are not intended for licensed food
establishments. This option will add heat and time to cycle.
At end of the cycle, the sanitized indicator (or word
"sanitized" on some models) will glow. If your load did not
properly sanitize, the indicator will flash at the end of the
cycle. This can happen if cycle is interrupted, or if the water
does not reach the required temperature. The light goes off
when you open and close the door or press CANCEL.
Auto Increased main :04 to 1:15 0 - 3.0
PowerBlastT- wash temperature (0 - 11.2)
Normal from 105°F (41°C)
to 145°F (63°C)
and final rinse
from 140°F (60°C)
to 156°F (69°0).
O
............... i
start
resume
sanitize
o
control lock
hold 3 sec
Press to start
or resume a
wash cycle
J
Ifthe door is opened during a cycle or power is interrupted, Start/Resume indicator flashes. Cycle will
not resume until door is closed and Start/Resume is pressed.
NOTE: If START/RESUME button is located on top of door, push door firmly closed within 4 seconds
of pressing START/RESUME. If door is not closed within 4 seconds, start button LED will flash, an
audible tone will be heard (on some top control models), and cycle will not start.
Control Lock
avoids
unintended
use of
dishwasher
between
cycles, or
cycle and
option
Toturn on Lock, press and hold CONTROL LOCK or SANITIZE (depending on model) for 3 seconds.
Control Lock light will stay on for a short time, indicating that it is activated and all buttons are
disabled. Ifyou press any button while your dishwasher is locked, light flashes 3 times. Dishwasher
door can still be opened/closed while controls are locked.
Toturn off Lock, press and hold CONTROL LOCK or SANITIZE (depending on model) for 3 seconds.
Light turns off.
NOTE: If your model requires you to press and hold SANITIZE to lock controls, Control Locked
LED(C) will be on or off to indicate whether Control Lock is active or not.
changes
during a cycle.
Loading...