Maytag MAV7501EWQ, MAV7501EWW Dimension Guide

www.dexpress.com DIMENSION EXPRESS Fax on Demand (775) 833-3600

This Data Sheet Includes Information On

Maytag

• Product Model Number (s): •

MAV7501EWQ and MAV7501EWW

• Dimensions (Actual Size) •

Height from floor to top of open door:

Height from floor to top of working

• Additional Information •

• Measurements are at 0" leg adjustment.

• Electrical requirements: 120V, 60Hz, 15 ampere grounded, fused electrical supply is required. An individual branch (or separate circuit serving only this appliance is recommended). Equipped with 3 prong power cord.

• Maximum amperage draw is 6 amps (except for motor starting surges).

• Minimum wire size of 14 gauge (No. 12 preferred), copper wire only.

• Flush to wall installation possible.

• Water supply: 30 to 120 psi water pressure. 140°F hot water supply recommended. 5 foot length HOT and COLD fill hoses provided. Access for manual shut-off water faucets recommended. Suggested water line size is 3/8" or 1/2" O.D.

• Drain: Standpipe of 36" in height is recommended (48" maximum).Drain system must accept 1 1/2" O.D. drain hose. Washer will discharge water at a rate of about 20 gals/min. 4 foot long drain hose supplied.

• Use of built in laundry wall box can simplify installation.

• Flooring requirements: Well braced solid floor (washer with load and water weighs approx. 350 lbs. Floor must be stable enough to prevent excessive vibration during spin.

• Installation on carpeting or soft tile requires kit

204986.

Washers:

Height:

Depth:

Width:

surface:

43 3/8" 28 1/4" 27" 53 1/8"

36 3/8"

at 0" leg adj.

0" wall clearance permissible on both sides

Back view

Plumbing

locations on

back of unit

(not to scale)

14" max.

53 1/8"

36 3/8" Leg Adj.

20"

at 0"

29 7/16"

28 1/4"

27"

Side View

(not to scale)

Closet door

Front View

(not to scale)

43 3/8"

at 0"

Leg Adj.

Water

intakes

4 1/2"

Drain

Subject to change without notice. This system is designed to be updated daily if necessary. Dimension Express is not responsible for use of superseded, voided, or outdated data sheets. Because of the difficulty or impracticability of determining actual damages, liability of Dimension Express shall not exceed $50.00. Copyright © Dimension Express, 2002.

• NEVER reuse Data Sheets. Data Sheets are subject to change without • Call Dimension Express if you have any questions at (775) 833-3633 • notice. Dimension Express is a FREE service bureau and is updated daily, • Always refer to a current Code at a Glance or manufacturer directory • it makes far more sense to spend the time necessary to request new Data • Data Sheet codes change on the first of odd numbered months at 12:01am • Sheets for each project, as opposed to the problems, time, costs, and risks associated with reusing old Data Sheets.

275

BN102 • A275 • • 032603 • 9570 • 50286