Maytag M7dh45b2a, M7dh65b2a Owner's Manual

For Future Reference

Write down the model and serial numbers

The model and serial numbers can be found back of the unit. Use these numbers in any

correspondence or service calls concerning your air conditioner.

Para referencia futura

Escriba los numeros del modelo y de la serie

Puede encontrar los n_meros de modelo y de serie en el parte posterior del acondicionador. Use estos numeros en

cualquier correspondencia o llamada de servicio con relaci6n a su acondicionador de aim.

Dehumidifier

Deshumificador

Ddshumidificateur

Pour r6f6rence ult6rieure

Inscrivez les numeros de modele et de serie

Les numeros de module et de s_rie se trouvent sur le c6t_ de arri_re de l'appareil. Utilisez ces num_ros lors de toute

correspondance ou appel au service apres-vente ayant trait

votre climatiseur.

Model No.. Modelo No. N ° de modH_

Serial No., NAmero de seri_, N ° de s(rie

Date of Purchase, Fecha de la compra, Date d'achat

@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@

@ @ @ @ @

@ @

@ @ @

Keep these instructions for future reference

For additional questions please call:

866-MAYTAG 1

MAYIAG

@ @ @ @ @ @ @

1. ELECTRICAL REQUIREMENTS

Electrical Shock Hazard

1. Plug unit only into grounded de_trical outlet.

2. Do not use an extension cord or pkb{ adaptor with

this uniL

3. Do not operate unit with front renloved.

Failure to follow the above precautions could result in electrical shock, fire or personal injury.

If the dehumidifier has a serial plate rating of 115 volts and up to and including 7.5 anlps the unit illay be on a fuse or drcuit breaker with other devices. However, the maximum amps of all devices on that fuse orcircuit breaker can not exceed the amps of the fuse or circuit breaker.

The Io_ation of the serial plate that applies to this model

call be found on the back page of this nlanua[.

For Your Safety:

Do not store or use gasoline or other flanlmable vapors and liquids in the vicinity of this or any other appliance. The

fumes call create a fire hazard or explosion.

Power Supply: 115

Notice

Do not operate this dehumidifier without proper time delay

circuit protection. Refer to serial plate for proper power supply requirenlents.

RECOMMENDED CIRCUIT WIRESIZES

(Asinstalledper building code)

PROTECTORSIZE WIRE GAUGE

15 AMP #14 MINIMUM 20 AMP #12 MINIMUM _0 AMP #10 MINIMUM

Minimum Wire Size: #14 (A.

Circuit Protector

@©©@

l l5V 230V 230V 230V

15A 15A 20A 30A

This dehumidifier has been carefully engineered, manufactured and tested to give you many years of

comfort and dependable operation.

AC Only I-,

125

or Circuit I

Grounded

three-prong

wall receptacle wall receptacle

Three-prong

grounding plug

ir_1

Single outlet

grounding

|mportant

Grou.di.g Requireme.ts

Your Dehumidifier will operate on any

115 volt, 3-pronged (grounded), 60 Hz

circuit. A separate line is not required, but it is advisable not to overload the

circuit with heavy duty appliances such

as washing machines, etc. For your

safety, this dehumidifier is equipped with a 3-pronged, grounding plug and must

be plugged into a properly grounded outlet (Figs. i & 2). If your outlet is not

of the proper type, it is your responsibility to have the outlet and

wiring changed to the correct type. DO NOT cut off the third (grounding) prong.

DO NOT USE AN ADAI_ER.

THIS IMPORTANT INFORMATION tells you all you need to know about installing, using and caring for

your new Dehumidifier. Keep it handy, it will answer your questions, save you time and expense, and insure

that, as the owner of this superb appliance, you receive maximum comfort and enjoyment for many years.

Close Windows and Doors

To assure efficient dehumidification, close all windows and doors in the area where the

dehumidifier is to operate,

Plug In

Once you have assembled your dehumidifier and installed it in an appropriate location, plug the cord

into a properly grounded outlet as indicated in the electrical requirement.

Power

Indicator

_MAY[A G

Container Full Set Humidity

Indicator Display

Room

Humidity/Temp Fan Speed

Display Indicators

Pause

Power

Power Pause Humidistat

Control Feature Adjustment

I houl

Operation

1. Allow dehumidifier to reach room temperature.

2. Press "Power" button to activate unit. Power "On"

indicator lights up and fan will run at low speed. The unit is pre-set to maintain a 60% relative humidity

level.

If "Set Humidity" level is lower than the "Room" humidity level: the compressor will start up and unit

will start dehumidification. If "Set Humidity" level is higher than the "Room" level:

the unit will continue to run on low fan.

After operating several days at the default setting, with doors and windows closed, you may adjust the "Set

Humidity" to a slightly lower percent (drier air) or higher percent (moist air). If you would like to adjust

the "Set Humidity" humidity level, press the "+" or "-" to adjust the humidistat in 5% increments between 30%

and 90%.

The "Room" display will display either the relative humidity or temperature of the room. The default

setting is room humidity. To display the temperature of the room press the "Humidity/Temp" button. Press it

again to go back to the humidity level. To display the Temperature in Centigrade: hold down

the "Humidity/Temp" button for S seconds.

To empty the Container:

Controls

Humidity/Temp

Fan _ ...................

Humidity/Temperature Fan speed

Display toggle Control

Press the "Fan Speed" button if you would like to change the fan speed from "Low" to "High", Use the high speed to maintain maximum water removal. The lower

speed can be used when quieter operation is desired.

Press "Pause" button to pause operation of dehumidifier for 1 hour.

8,9.An automatic overflow switch and Container "Full"

indicator light are provided to turn the dehumidifier off before the container overflows. When the indicator

light on the control panel glows, the water container must be emptied.

If Set humidity is set to 30% then unit is in "continuous run" mode. While in this mode the compressor will

continuously run regardless of actual room Humidity. If not properly monitored this setting could

cause excess energy usage.

Note: A piece of tape is attached to the container to ensure

safe sh pp rig. Th s p ece of tape can be removed.

Handle

When the condensate water container is full, the indicator lights

up.

1. Turn the power off before removing container. Wait 3 minutes for any remaining water to drain into the

condensate container.

2. Tilt the container forward then lift carefully by the handle.

3. Clean and gently re-insert the container.

Condensate Container

Important: This water is not suitable for drinking.

Filter Cleaning

1. Turn tile power off.

2. Use a vacuum cleaner attachment or brush to clean the front grille.

3. Remove the filter by sliding the filter out using the recessed "finger-tip" tab.

3. To clean the filter, wash in warm, soapy water, rinse and shake dry.

Cleaning is recommended monthly, or as conditions require.

4. For cleaning the water container, and wash with warm soapy water.

Properuseandcare of your dehumidifierwill helpensure longer life of the unit. It is recommended to annuallyinspectandcleanthe coilsandcondensatewaterpassages.Expenseof annualinspectionisthe consumers'responsibility.

Condensate

Drain

Filter

Permanant Drain Installation (optional):

The condesate water can be removed directly from the unit

to a drain through a garden hose with the included

adapter.

1. Turn the power off before beginning work.

2. Use a screwdriver to remove the knock-out at the back of the unit. (Fig. 1)

3. Slide the garden hose adapter (supplied) over the condensate drain through the knock-out hole. (Fig 2)

4. The garden hose should lead to a floor drain or other

appropriate drain source. The garden hose should have

no inclines or sharp bends.(Fig 2)

Permanant drain knock-out

Back of unit

o ¢

\ (Fig. 1)

Service (Read carefully before calling for service)

If the Dehumidifier Fails to Start

• Make sure the unit is plugged into an operating outlet.

• If the indicator light (most models) is on, empty the full water container. The indicator light should now go OFF, and

the dehumidifier will begin to operate so be sure to quickly reinsert the empty water container. If the dehumidifier does

not begin to operate make sure the float is attached to the

water container.

Unit Runs, But Very Little Water is Collected

• The amount of water removed from the air depends on the relative humidity of the air and the capacity of the

dehumidifier purchased. When the air feels damp (high relative humidity), more moisture will be removed and the

container will fill up more rapidly. As the unit continues to remove moisture and reduce the humidity in the area, less

water will be collected in the container.

• This unit is equipped with a defrost control, which will automatically activate when needed. When in defrost mode

the compressor will cycle on and off and the unit will make less water.

Side View

Condensate _ l l Drain Hose Adapter Garden Hose

(Fig. 2)

To floor drain

I I

Save Electricity

• In general, dehumidification is not usually needed during conditions of low room temperature (below 6S°F) or low

relative humidity. To save electricity and prevent, it is best to turn the unit OFF during conditions of low room

temperature.

Sounds

It is reassuring to know that your dehumidifier is functioning properly. These are some normal sounds which should not be

a cause for concern:

• Air rushing over air drying coils.

• Hissing or thumping - refrigerant is flowing throughout the sealed system and may generate a "boiling" sound right

after the compressor stops.

• Compressor may "thump" as it cycles on and off.

• Water dripping from coils onto the drain plate.

• The humidistat control, compressor and fan "tick" as they turn on and off. Metal makes a similar sound when

expanding or contracting.

• Room humidity is low (below 40%).

Service and Warrantyooooooooooooooooooooooooooooooooooo

Warranty

For Models Installed in North America - If Service or Parts are Required

First, make the recommended checks. If it appears that service or parts are still required, see your room dehumidifier warranty

"How to Obtain Warranty Service or Parts". For Models Installed Outside North America

For dehumidifiers purchased for use outside North America, the manufacturer does not extend any warranty either expressed or

implied. Consult your local dealer for any warranty terms extended by the importer in your country.

Room dehumidifier Warranty

(Within the 48 contiguous United States, state of Hawaii,

the District of Columbia, Puerto Rico and Canada)

Full (FiveYear) Parts and Labor Warranty During the five years after the date of original purchase, Fedders

North America will, through its authorized servicers and free of charge to the owner or any subsequent user, repair or replace any

parts which are defective in material or workmanship due to normal use when the unit is delivered by the owner to and

picked up from one of our authorized servicers. If requested, in- home service, pick-up, redelivery and reinstallation will be

provided, but are the owner's responsibility.

Note: In the event of any required parts replacement within the period of this warranty. Fedders North America replacement parts shall be used and will be warranted only for the period remaining on the original warranty.

Exceptions

The above warranty does not cover failure to function caused by damage to the unit while in your possession (other than damage

caused by defect or malfunction), or by its improper installation, or by unreasonable use of the unit, including without limitation,

failure to provide reasonable and necessary maintenance or to follow the written Installation and Operating Instructions. If the

unit is put to commercial, business, rental, or other use or application other than for consumer use, we make no warranties,

express or implied, including but not limited to, any implied warranty of merchantability or fitness for particular use or

purpose.

THE REMEDIES PROVIDED FOR IN THE ABOVE EXPRESS WARRANTY ARE THE SOLE AND EXCLUSIVE REMEDIES

THEREFOR, NO OTHER EXPRESS WARRANTIES ARE MADE. ALL IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED

TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE OR PURPOSE, ARE LIMITED

IN DURATION TO FIVE YEARS FROM THE DATE OF ORIGINAL PURCHASE. IN NO EVENT SHALL FEDDERS NORTH AMERICA

BE LIABLE FOR INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF ADVISED IN ADVANCE OF THE POSSIBILITY OF SUCH DAMAGES. NO WARRANTIES,

EXPRESS OR IMPLIED, ARE MADE TO ANY BUYER UPON RESALE.

Some states do not allow limitations on how long an implied warranty lasts or do not allow the exclusion or limitation of

incidental or consequential damages, so the above limitations

or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which

may vary from state to state.

No warranties are made for units sold outside of the above

stated areas. Your distributor or final seller may provide a warranty on units sold outside of these areas.

How to Obtain Warranty Service or Parts

Service for your dehumidifier will be provided by CareCo, a division of the manufacturer with authorized independent

CareCo servicers nationwide.

Note: Before calling for service, carefully read the Installation and Operating Instructions booklet. Then if you need service:

1. Call a CareCo authorized servicer and advise them of model number, serial number, date of purchase and nature of

complaint. Service will be provided during normal working

hours. Contact your dealer for the name of an authorized

servicer if unknown to you.

2. If your dealer is unable to give you the name of a servicer or if you need other assistance, call the following toll-free

number for the name of an authorized servicer or authorized parts distributor:

1-866-MAYTAG 1

or you may write: CareCo, Service Department

415 W. Wabash Ave., P.O. Box 200 Effingham, IL 62401

Proof of Purchase Date

It is the responsibility of the consumer to establish the original

purchase date for warranty purposes. We recommend that a bill of sale, cancelled check, or some other appropriate payment

record be kept for that purpose.

+ 10 hidden pages