Maytag CWG3600AAS13, CWG3100AAE29, CWG3100AAS13, CWG3600AAB26, CWG3100AAB25 Installation Guide

INSTALLATIONINSTRUCTIONS

24" (61.0 CM) GAS SINGLE

AND DOUBLEBUILT-INOVEN

Table of Contents

BUILT-IN OVEN SAFETY ................................1

INSTALLATIONREQUIREMENTS.................3

Toolsand Parts.............................................3

Location Requirements.................................3

ElectricalRequirements................................4

GasSupply Requirements............................5

INSTALLATION INSTRUCTIONS...................6

PrepareBuilt-In Oven....................................6

MakeGas Connection ..................................6

InstallOven....................................................7

Complete Installation....................................8

GAS CONVERSIONS.......................................9

LPGasConversion .......................................9

NaturalGasConversion..............................10

BUILT-INOVEN SAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety

messages.

This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."

These words mean:

You can be killed or seriously injured if you don't immediately

follow instructions.

You can be killed or seriously injured if you don't follow instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

iMPORTANT:

installer: Leave installation instructions with the homeowner.

Homeowner: Keep installation instructions for future reference.

W10203509A

WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.

- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

- WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

• Do not touch any electrical switch.

• Do not use any phone in your building.

• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's

instructions.

• If you cannot reach your gas supplier, call the fire department.

- Installation and service must be performed by a qualified installer, service agency or the gas supplier,

WARNING: Gas leaks cannot always be detected by smell.

Gas suppliers recommend that you use a gas detector approved by UL or CSA. For more information, contact your gas supplier.

If a gas leak is detected, follow the "What to do if you smell gas" instructions.

In the State of Massachusetts, the following installation instructions apply: [] Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by

the State of Massachusetts.

[] If using a ball valve, it shall be a T-handle type. [] A flexible gas connector, when used, must not exceed 3 feet.

INSTALLATIONREQUIREMENTS

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed

here.

Tools needed

• Tape measure • Marker or pencil

• Phillips screwdriver • Pipe-joint compound

• Flat-blade screwdriver

• 1/8"Flat-blade screwdriver • 3/16"(4.8 mm) carbide-tipped

• Level concrete/ceramic floors)

• Hand or electric drill • Noncorrosive leak-detection

• Wrench or pliers

• Pipe wrench Conversions

• 1%6"combination wrench • 1/2"combination wrench

• 1/8"(3.2 ram) drill bit • 7 mm nut driver (for wood floors)

Parts needed

Check local codes and consult gas supplier. Check existing gas supply and electrical supply. See "Electrical Requirements" and "Gas Supply Requirements" sections.

resistant to LP gas

masonry drill bit (for

solution

For LP/Natural Gas

• Masking tape

Product Dimensions - Single Oven

A. 221/4''(56.8 cm) max. recessed width B. 391/4''(99. 7cm) max. overall height C. 23%" (60.6 cm) overall width D. 22%" (57.5 cm) max. recessed depth E. 3 73/4"(95.9 cm) recessed height

Cabinet Dimensions - Single Oven

IMPORTANT: Observe all governing codes and ordinances. Do

not obstruct flow of combustion and ventilation air.

It is the installer's responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located at bottom front face

surface on the right-hand side of the oven frame.

• The oven should be located for convenient use in the kitchen. Recessed installation area must provide complete enclosure

around the recessed portion of the oven. All openings in the wall or floor where oven is to be installed

must be sealed. Cabinet opening dimensions that are shown must be used.

Given dimensions provide minimum clearance with oven. Grounded electrical supply is required. See "Electrical

Requirements" section. Proper gas supply connection must be available. See "Gas

Supply Requirements" section.

IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. This oven has been designed in accordance with the requirements of UL

and CSA International and complies with the maximum allowable wood cabinet temperatures of 194°F (90°C).

Single Oven Installed in Cabinet

I II I

A. 24" (61 cm) min. cabinet width B. 11/_"(3.8 cm) top of cutout to bottom of upper cabinet

door C. 14" (35.6 cm) min. bottom of cutout to floor D. 22%" (56.8 cm) cutout width

E. 11/_'' (3.8 cm) min. bottom of cutout to top of cabinet door F. 38" (96.5 cm) cutout height

NOTE: For gas supply pipe, provide a 3" x 3" opening in the back wall of the cabinet centered 7" from the left rear corner and 3"

above the bottom of the cabinet cut out. Install a 120 volt electrical outlet in the back wall of the cabinet centered 6" from

the right rear corner and 4" below the top of the cabinet cutout.

Product Dimensions - Double Oven

A. 221/4''(56.8 cm) max. recessed width

B. 46%6" (117.6 cm) max. overall height C. 237/8''(60.6 cm) overall width

D. 22%" (57.5 cm) max. recessed depth

E. 443/4''(113.4 cm) recessed height

Cabinet Side View - Double or Single Oven

A. 24" (61 cm) min. cutout depth B. 22%" (57.5 cm) recessed oven depth

C. Oven front D. Recessed oven

E.Cabinet

Cabinet Dimensions - Double Oven

DoubleOven Installed inCabinet

A. 24" (61 cm) min. cabinet width

B. 11/2''(3.8 cm) top of cutout to bottom of upper

cabinet door

C. 14" (35.6 cm) min. bottom of cutout to floor D. 223/8'' (56.8 cm) cutout width

E. 11/2''(3.8 cm) min. bottom of cutout to top of

cabinet door

F. 453/8'' (115.3 cm) cutout height

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong. Do not use an adapter.

Do not use an extension cord. Failure to follow these instructions can result in death,

fire, or electrical shock.

IMPORTANT: The oven must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or

Canadian Electrical Code, CSA C22.1. If codes permit and a separate ground wire is used, it is

recommended that a qualified electrical installer determine that the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

NOTE: For gas supply pipe, provide a 3" x 3" opening in the back wall of the cabinet centered 7" from the left rear corner and 3"

above the bottom of the cabinet cutout. Install a 120 volt electrical outlet in the back wall of the cabinet centered 6" from the right

rear corner and 4" below the top of the cabinet cutout.

+ 8 hidden pages