Maytag CWE4100ACB10, CWE4800ACS14, CWE5800ACE28, CWE5800ACS14, CWE5800ACB25 Installation Guide

...

INSTALLATION INSTRUCTIONS

24" (61.0 CM) ELECTRIC SINGLE AND DOUBLE

BUILT-IN OVEN

Table of Contents

BUILT-IN OVEN SAFETY ............................................................... 1

INSTALLATION REQUIREMENTS ................................................ 2

Tools and Parts............................................................................ 2

Location Requirements ............................................................... 2

Electrical Requirements ............................................................... 3

INSTALLATION INSTRUCTIONS .................................................. 4

Prepare Built-In Oven .................................................................. 4

Oven Door .................................................................................... 4

Make Electrical Connection ......................................................... 5

Install Oven .................................................................................. 7

Complete Installation ................................................................... 8

BUILT-IN OVEN SAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety

messages.

This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."

These words mean:

You can be killed or seriously injured if you don't immediately

follow instructions.

You can be killed or seriously injured if you don't follow instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

iMPORTANT:

Save for local electrical inspector's use.

W10203506A

INSTALLATION REQUIREMENTS

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed

here.

Tools needed

• Phillips screwdriver

• Measuring tape

• Hand or electric drill (for wall cabinet installations)

• 1" (25 mm) drill bit (for wall cabinet installations)

• Level

Parts needed

• UL listed or CSA approved conduit connector

• UL listed wire connectors

Product Dimensions - Single Oven

Parts supplied

• 0.188 x 2.1" screws - single oven (4), double oven (6) Check local codes. Check existing electrical supply. See

"Electrical Requirements." It is recommended that all electrical connections be made by a

licensed, qualified electrical installer.

._@] _, ;: ,,._,_

IMPORTANT: Observe all governing codes and ordinances.

• Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance with oven.

• Recessed installation area must provide complete enclosure around the recessed portion of the oven.

• Grounded electrical supply is required. See "Electrical Requirements" section.

• Electrical supply junction box should be located in the upper right corner, 4" (10.2 cm) below the upper cut out surface of the cabinet.

Oven support surface must be solid, level and flush with bottom of cabinet cutout. Floor must be able to support a single oven weight of 154 Ibs (70 kg) or a double oven weight of 287 Ibs (130 kg).

A. 221/4''(56.5 cm) max. recessed width B. 29%" (75.3 cm) max. overafl height C. 23%" (60.6 cm) overall width D. 22%" (57.5 cm) max. recessed depth E. 2 77/8"(70.8 cm) recessed height

Cabinet Dimensions - Single Oven

Single Oven Installed in Cabinet

IIII

A. 24" (61 cm) min. cabinet width B. 11/_"(3.8 cm) top of cutout to bottom of upper cabinet

door

C. 331/4'' (84.5 cm) min. bottom of cutout to floor D. 22%" (56.8 cm) cutout width

E. 11/_'' (3.8 cm) min. bottom of cutout to top of cabinet door F. 2811A6'' (72.9 cm) cutout height

Product Dimensions - Double Oven

Cabinet Side View - Double or Single Oven

A. 24"(61 cm) min. cutout depth B. 22%" (57.5 cm) recessed oven depth

C. Oven front D. Recessed oven

E.Cabinet

A. 221/4''(56.5 cm) max. recessed width

B. 46%6" (117.6 cm) max. overafl height C. 237/8''(60.6 cm) overafl width

D. 22%" (57.5 cm) max. recessed depth

E. 44%" (113.4 cm) recessed height

Cabinet Dimensions - Double Oven

Double Oven Installedin Cabinet

A. 24" (61 cm) min. cabinet width

B. 11/2''(3.8 cm) top of cutout to bottom of upper

cabinet door

C. 17" (43.2 cm) min. bottom of cutout to floor D. 223/8'' (56.8 cm) cutout width

E. 11/2''(3.8 cm) min. bottom of cutout to top of

cabinet door

F. 453/8'' (115.3 cm) cutout height

If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and the wire gauge are in accordance with local

codes. Check with a qualified electrical installer if you are not sure the

oven is properly grounded.

This oven must be connected to a grounded metal, permanent

wiring system. Be sure that the electrical connection and wire size are adequate

and in conformance with the National Electrical Code, ANSI/ NFPA 70-latest edition or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No. O-M91-1atest edition, and

all local codes and ordinances.

A copy of the above code standards can be obtained from:

National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

Electrical Connection

To properly install your oven, you must determine the type of

electrical connection you will be using and follow the instructions provided for it here.

• Oven must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located at the bottom right-hand oven surface. See the following illustration.

+ 5 hidden pages