A: I recommend using a non corroding leak detection fluid and apply the same on all joints and fittings around the gas in order to detect if there was any leakage.
A: Verify if there is proper gas connection and the surface control is turned to LITE position. If the burner keeps on not igniting, then verify if there is clogging, or even clean the burner ports.
A: Please do not exceed a maximum gas supply pressure of 14 inches water column (W.C.P.)
A: This is usually due to the accumulation of dirt in the burner ports. The solution to this is to clean the burner ports.
A: No, lining the bottom of an oven with foil can pose a fire risk and could damage the oven or range.