Maytag 12001725 User Manual

(3)- (MAYTAG) FRONT LOAD WASHER MACHINE
CONTROL BOARD KIT #12001454. AND #12001725.

Service

Instruction
Sheet

This instruction sheet is to be used with ;

REPAIR PART NO. : 12001454,12001725
DESCRIPTION : Machine Control Board Kit

MAYTAG

16008915

2707490-0200

This kit contains:

22002988 Machine Control Board 16002292 Schematic
22002335 Jumper Wire (Red Wire No. 3) 16008915 Instruction Sheet I
22002281 Pitot Lamp (Yellow based) |

The following chart will depict which components apply to the washer you
are servicing.

Model Number Prior to Series 17

MAHSOOOAm

MAH3000AWQ

A

A

MAH3000AWW A

^ = Use all components and follow instruction steps 1-11 below,

3 = Use only the 22002988 board and follow instruction steps 1,2, 9,10 & 11 below.

Series 17 & Later

B

B

B

StSESOAltD-LBrr

MOUNTING

NUTS

CONTNOt

MoywT»*a
emcKETs

I

rocedure:

t. Unplug the washer.

2. Remove the three screws securing the rear
console cover plate to the console and lay
the console forward carefully onto a service
blanket on the top cover.

3. Locate the ON Light in the console and remove
the Black No. 3 wire and the White No. 11
wire from the signal lamp assembly. Unsnap and
discard the ON Light lamp assembly.

4. Fold the Biack No. 3 wire back and tape the wire
to the main harness out of the way.

5. Locate and remove connector P7 from the left
side of the Machine Control board.

6. Insert the jumper wire (Red Wine No. 3), found in
the service repair assembly into position
number 5 of the P7 connector, then reconnect the
P7 connector back onto the Machine
Control Board.

7. Remove the Yellow based indicator lamp found in

the service assembly and position the
lamp where the previous ON Light lamp assem
bly was previously removed. Then snap the new
lamp assembly into the console.

8. Connect the V^ite No. 11 vwre and the Red No. 3

wre to the new yellow based lamp as^mbly.

9. Remove the existing electrical schematic taped to

the rear wall of the console and replace
with the electrical schematic found in the service

assembly.

10. Reposition the console into the upright position

on the topcover and secure the three
SCTews fastening the console to the rear console
cover plate.

11. Replacement is complete.

1