Maytag 12001454 User Manual

(3)- (MAYTAG) FRONT LOAD WASHER MACHINE
CONTROL BOARD KIT #12001454_ AND #12001725.

Se ,ce Yr IG

Instruction

16008915

Sheet

2707490-0200

This instruction sheet is to be used with :

REPAIR PART NO. : 12001454, 12001725

DESCRIPTION: Machine Control Board Kit

II II II II

This kit contains:
22002988 Machine Control Board 16002292 Schematic

22002335 Jumper Wire (Red Wire No. 3) 16008915 Instruction Sheet
22002281 Pilot Lamp (Yellow based)

I I

The following chart will depict which components apply to the washer you
are servicing.

i

Model Number

MAH300OAWA

MAI_000AWQ

MAH3000A_

= Use all components and follow instruction steps 1 - 11 below.

B = Use only the 22002988 board and follow instruction steps 1,2, 9, 10 & 11 below.
Procedure:

1.unplug the washer.

Z Remove the three screws securing the rear

console cover plate tothe console and lay

the console forward carefully onto a sen,ice

blanket on the top cover.

3. Locate the ON Lightin the console and remove
the Black No. 3 wireand theWhite ,'Jo.11

wire from the signallamp assembly. Unsnap and

discard the ON Light lamp assembly.

4. Fold the Black No. 3 wire back and tape the wire

to the main harness out of the way.

5. Locate and remove connector P7 from the left
side of the Machine Control board.

6. Insert the jumper wire (Red Wire No. 3), found in

the service repair assembly, into position

number 5 of the P7 connector, then reconnect the
P7 connector beck onto the Machine
Control Board.

Prior to Series 17

A

A

A

Series 17 & Later

B

B

B

7. Remove the Yellow based indicator lamp found in

the service assembly and position the
lamp where the previous ON Light lamp assem-

bly was previously removed. Then snap the new
lamp assembly into the console.

8, Connect the White No. 11 wire and the Red No. 3

wire to the new yellow based lamp assembly.

9, Remove the existing electrical schematic taped to

the rear wall of the console and replace
with the electdcal schematic found in the service

assembly.

lO,Reposition the console into the updght position

on the topcover and secure the three
screws fastening the console to the rear console

cover plate.

11.Replacement is complete.

84.iDEBOARD - LEFT