MayPole MP7410, MP7411 User Manual

Digital Wireless Reversing Camera System (MP7410) &

Additional Camera MP7411

2

INTRODUCTION

The MP7410 digital wireless reversing camera system with built in transmitter when used as described will improve your ability to
see behind your car, camper, trailer, or horse box. Numerous measures in quality control have been taken to ensure that your
product arrives in top condition and will perform to your satisfaction.

Please carefully read and follow the following safety and operating instructions.

IMPORTANT SAFETY INSTRUCTIONS

Before You Install

If you are not confident working with 12V/24V DC vehicle wiring, removing and reinstalling interior panels, carpeting, dashboards
or other components of your vehicle, consider having the camera system professionally installed.

Carefully consider the location of any new holes before drilling. It is important to take precautions to prevent damage to the
vehicle’s electrical and fuel system.

Interference

This device is immune from interference from other wireless devices; Bluetooth, mobile telephones, Wi-FI routers, power lines
and other various electrical equipment.

Repair

The camera system contains no user serviceable parts and should not be opened. Any attempt at modification or repair by the
user will entail the loss of your guarantee.

COMPONENTS

1). Monitor 2). Camera

3). Mounting accessories 4). Flush mounting plate

5). Monitor power cable 6). Mounting arm
7 & 8). Surface mounting plates

3

INSTALLATION

These instructions do not apply to all vehicles. They are only meant as a general guide due to the number of different makes &
models. For vehicle specific questions contact your vehicle’s manufacturer.

Camera installation

There are several ways to mount the camera on the back of your car. But the most convenient is to mount it near the number
plate. Supplied within the kit are two mounting plates; one is intended to be fixed behind the number plate, and the other is for
surface mounted installation. Once the camera is affixed to either mounting plate the camera can be adjusted manually on its
vertical axis. Ensure that the cameras field of vision is not obstructed.

Bracket for licence plate mounting

A1. Remove the rear number plate; the plate may be affixed either directly to the vehicle or via a mounting bracket.
Dependant on the vehicle, screws/bolts or sticky pads may be used.

A2. If your vehicle utilizes a mounting bracket, position the camera mounting bracket (together with camera) behind the
number plate bracket if possible. Secure number plate bracket and mounting plates back to the vehicle with the original bracket
fixings.

A3. The number plate can then be remounted onto the bracket. If your vehicle is not supplied with a number plate mounting
bracket the camera can be mounted directly onto the number plate.

NOTE: ENSURE THAT THE CAMERA OR BRACKET DOES NOT OBSCURE ANY PART OF THE VEHICLE NUMBER PLATE!