Mayline SR6033 User Manual

2 - Tier Sorter (No Riser),

60"W x 33 1/4"H x 13 1/4"D

Kwik-File, LLC

Two-Tier Sorter

SR6033

Parts list and drawings for 2 - Tier Sorter (No Riser).

(1)

1. No tools required: Unpack carton and identify all parts. Peel off protective film from face side of all
flat steel parts.

2. Position the two outside end panels (flange side up) and the two back panels (tab side up) as
shown on a clean, flat, smooth surface. Bottom back panel has wire cutouts on bottom.

3. Lift up one side of the bottom back panel and insert tabs through the lower slots in the adjacent
end panel. Repeat with other side. Then do the same with top back panel. The lower edge of the
top back panel will slightly overlap the upper edge of the lower back panel.

4. Place each of the inside end panels inside the outside end panels, loop side up; the offset lip fits

under the flange on the outer edge of the outside end panel. Note: the flange on the inside end
panel with the two holes should be facing down.

(2)